做BL的时候,主函数被改成了BLmian()
boot28.asm中 LCR _SBLmain,如此带返回调用主函数,这句话运行结束后,SBLmain函数的返回值是个APP的入口地址放在ACC中,通过 LCR _exit 调用,最终将ACC中的主函数入口地址加载到PC中
因此, _exit函数的内容要加到boot28.asm中,不然引用的_exit是库中的,没有上面这个过程,就无法完成跳转
添加到boot28.asm中的代码如下:
_exit:
;-----------------------------------------------
; Insure that the stack is deallocated
;-----------------------------------------------
MOV SP,#__stack
;-----------------------------------------------
; Clear the bottom of the stack. This will endup
; in RPC when we are finished
;-----------------------------------------------
MOV *SP++,#0
MOV *SP++,#0
;-----------------------------------------------
; Load RPC with the entry point as determined
; by the boot mode. This address will be returned
; in the ACC register.
;-----------------------------------------------
PUSH ACC
POP RPC
;-----------------------------------------------
; Put registers back in their reset state.
;
; Clear all the XARn, ACC, XT, and P and DP
; registers
;
; NOTE: Leave the device in C28x operating mode
; (OBJMODE = 1, AMODE = 0)
;-----------------------------------------------
ZAPA
MOVL XT,ACC
MOVZ AR0,AL
MOVZ AR1,AL
MOVZ AR2,AL
MOVZ AR3,AL
MOVZ AR4,AL
MOVZ AR5,AL
MOVZ AR6,AL
MOVZ AR7,AL
MOVW DP, #0
;------------------------------------------------
; Restore ST0 and ST1. Note OBJMODE is
; the only bit not restored to its reset state.
; OBJMODE is left set for C28x object operating
; mode.
;
; ST0 = 0x0000 ST1 = 0x0A0B
; 15:10 OVC = 0 15:13 ARP = 0
; 9: 7 PM = 0 12 XF = 0
; 6 V = 0 11 M0M1MAP = 1
; 5 N = 0 10 reserved
; 4 Z = 0 9 OBJMODE = 1
; 3 C = 0 8 AMODE = 0
; 2 TC = 0 7 IDLESTAT = 0
; 1 OVM = 0 6 EALLOW = 0
; 0 SXM = 0 5 LOOP = 0
; 4 SPA = 0
; 3 VMAP = 1
; 2 PAGE0 = 0
; 1 DBGM = 1
; 0 INTM = 1
;-----------------------------------------------
MOV *SP++,#0
MOV *SP++,#0x0A0B
POP ST1
POP ST0
;------------------------------------------------
; Jump to the EntryAddr as defined by the
; boot mode selected and continue execution
;-----------------------------------------------
LRETR