HIgrow（ESP32 Rev1 WiFi 蓝牙电池 DHT11土壤温度湿度传感器模块）使用指南

Higrow使用指南

作者：coolwaterld

邮箱：coolwaterld@hotmail.com

安装arduino （windows）

https://downloads.arduino.cc/arduino-1.8.7-windows.exe

 

安装ESP32扩展

https://randomnerdtutorials.com/installing-the-esp32-board-in-arduino-ide-windows-instructions/

1) Open the preferences window from the Arduino IDE. Go to File> Preferences

2) Enter https://dl.espressif.com/dl/package_esp32_index.jsoninto the “Additional Board Manager URLs” field as shown in the figure below. Then, click the “OK” button:

Note: if you already have the ESP8266 boards URL, you can separate the URLs with a comma as follows:

https://dl.espressif.com/dl/package_esp32_index.json, 

http://arduino.esp8266.com/stable/package_esp8266com_index.json

3) Open boards manager. Go to Tools > Board > Boards Manager…

4) Search for ESP32 and press install button for the “ESP32 by Espressif Systems“:

5) That’s it. It should be installed after a few seconds.

（国内download github内容可能会失败，隔一段时间再试试即可）

Higrow硬件介绍

用于ESP32 Rev1 WiFi＆蓝牙电池和DHT11开发板的土壤温度检测模块和湿度传感器模块

 

1）介绍

https://www.higrow.tech/

https://hackaday.io/project/25253-higrow-plants-monitoring-sensor

https://github.com/lucafabbri/HiGrow-Arduino-Esp（原版）

https://github.com/LilyGO/higrowopen（改良版）

 

2）购买

https://item.taobao.com/item.htm?spm=a1z09.2.0.0.24252e8dxhxZus&id=577384707552&_u=6lou1pbc76（土壤传感器不需要飞线）

https://it.aliexpress.com/item/ESP32-WIFI-Bluetooth-battery-soil-Moisture-Senson-DHT/32815782900.html

 

 

连接设备到PC

用micro USB线连接设备到PC，micro USB既做供电也做通信（注意higrow的开关需要拨到ON上），在windows设备管理器上COM端口显示出USB to UART Brindge

 

 

下载Higrow程序

https://github.com/LilyGO/higrowopen（改良版）

修改程序：

添加你的wifi的名称和密码

const char* ssid     = "名称";

const char* password = "密码";

 

下载DHT的库文件

搜索DHT，选择DHT sensor Library

注意版本不要选择v1.3.0，可以选1.2.3

按键Install

关于arduino的硬件参数配置

关于烧写

Connecting…..时按住higrow 的boot键才能正确烧写

烧写完成的标志：

 

串口监测程序

串口波特率115200

获得IP地址192.168.3.41，在浏览器中黏贴改地址