VIA1003C11A0000 ISH100/30058/0/1/00/0/00/00/00 时基10毫秒

如果未找到GSD文件，则用户可以通过单击文本no GSD found旁边的图标将预期的GSD复制到设备目录。这将启动“安装新的GS*文件”对话框。安装文件后，PROFIBUS主配置窗口将验证安装的文件是否与从设备匹配，并相应地更新从设备的模块。重新扫描按下YES按钮将触发新的网络扫描。在继续扫描之前，将显示与下面类似的消息。如果接受新的扫描，则在上一次扫描中发现的检测到的从设备将丢失。采用选定的从机按下此按钮将使所有选定的从设备进入PROFIBUS主配置窗口。在继续执行此操作之前，将显示与下面类似的消息。 

字节位位置指定7 6 5 4 3 2 1 0锁定Reg Unio Req Sync Req Free Req WD on Res-Res Res Station status 1 WD_Fact_1 2 WD_Fact_2 3 MinTSDR 4 Ident_Number_High 5 Ident_Nnumber_Low 6 Group_Ident 7 Spec_User_Prm_Byte 8至243 User_Prm_Data字节7 Spec_User_Prm-Byte位名称意义默认状态0 Dis_Startbit接收器中的起始位监控用该位关闭Dis_Startbit=1，起始位监控被关闭。1接收器中的Dis_Stopbit停止位监控被此位关闭Dis_Stopbit=0停止位监控未被关闭。2 WD_Base此位指定用于给看门狗计时的时基。WD_Base=0：时基10毫秒WD_Base=1：时基1毫秒WD_Base=0时基为10毫秒。3到4 Res若要用0参数化，请使用0 5 Publisher_Enable SPC3的DXB发布者功能已用此位Publisher_Enable=0激活，DXB请求电报将被忽略；Publisher_Enable=1，DXB请求电报已处理6到7个Res将用0 0参数化

If no GSD-file is found the user will be able to copy the expected GSD to the device catalog by clicking the icon next to the text No GSD found. This will start the Install new GS*-file dialog box. When the file is installed, the PROFIBUS Master Configuration window will verify that the installed file matches the slave and update the modules for the slave accordingly. Rescan Pressing the YES button will trigger a new network scan. Before proceeding with the scan a message similar to the one below will appear. If a new scan is accepted, detected slaves found during the previous scan will be lost. Adopt selected slaves Pressing this button will cause all selected slaves to be adopted to the PROFIBUS Master Configuration window. Before carrying on with this action a message similar to the one below will appear.