单片机串口配置

  /*串口参数配置*/
  USART_InitStructure.USART_BaudRate = 115200;                 /*设置波特率为115200*/
  USART_InitStructure.USART_WordLength = USART_WordLength_8b;  /*设置数据位为8位*/
  USART_InitStructure.USART_StopBits = USART_StopBits_1;       /*设置停止位为1位*/
  USART_InitStructure.USART_Parity = USART_Parity_No;          /*无奇偶校验*/    
  USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None; /*没有硬件流控*/
  USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;      /*发送与接收*/
  /*完成串口COM1的时钟配置、GPIO配置，根据上述参数初始化并使能*/

  STM_EVAL_COMInit(COM1, &USART_InitStructure);

  完成上述配置之后，单片机就会有串口打印了