CC2640之第一个工程Simple_peripheral代码框架及学习

一、入口函数main

int main()
{
#if defined( USE_FPGA )
  HWREG(PRCM_BASE + PRCM_O_PDCTL0) &= ~PRCM_PDCTL0_RFC_ON;
  HWREG(PRCM_BASE + PRCM_O_PDCTL1) &= ~PRCM_PDCTL1_RFC_ON;
#endif // USE_FPGA
  
  /* Register Application callback to trap asserts raised in the Stack */
  //注册断言回调函数，断言是处理异常程序的方法之一
  RegisterAssertCback(AssertHandler);
  //初始化硬件GPIO口
  PIN_init(BoardGpioInitTable);

#ifdef CC1350_LAUNCHXL
  // Enable 2.4GHz Radio
  radCtrlHandle = PIN_open(&radCtrlState, radCtrlCfg);
  
#ifdef POWER_SAVING
  Power_registerNotify(&rFSwitchPowerNotifyObj, 
                       PowerCC26XX_ENTERING_STANDBY | PowerCC26XX_AWAKE_STANDBY,
                       (Power_NotifyFxn) rFSwitchNotifyCb, NULL);
#endif //POWER_SAVING
#endif //CC1350_LAUNCHXL

#if defined( USE_FPGA )
  // set RFC mode to support BLE
  // Note: This must be done before the RF Core is released from reset!
  SET_RFC_BL