HDMI1.4 Compliance Test Specification
转载本博客文章,请注明出处
TMDS通道阻抗要求
Characteristic differential impedance of the connector, for each differential TMDS pair is 100Ω ± 15%. A single excursion is permitted out to a maximum of 100ohm+/-25%.and of a duration less than 250psecs.
连接器特征阻抗要求100Ω ± 15%,允许单次偏移最大为100Ω ± 25%,持续时间小于250ps。
PCB走线阻抗控制要求
Characteristic differential impedance of the leads (cables or traces), for each adifferential TMDS pair, is 100Ω ± 5% as a average over the entire trace. Peak impedance of up to 100Ω ±10% is also permitted.
TMDS差分线阻抗平均值100Ω ± 5%,最大阻抗100Ω ± 10%。
DDC通道I2C容抗要求
source端测试:接入HPD信号,使用数字电桥测试DDC通道SCL/SDA对地容抗不超过50pF;
sink端测试:接入HDMI 5V电压,使用数字电桥测试DDC通道SCL/SDA对地容抗不超过50pF。
DDC通道具体容抗要求如下:
CEC Line容抗要求
所有HDMI端口CEC pin需连在一起,且容抗满足规范要求