- 博客(5)
- 资源 (3)
- 收藏
- 关注
转载 不同VLAN之间相互通信的两种方式(单臂路由、三层交换)
不同VLAN之间相互通信的两种方式(单臂路由、三层交换)试验环境:东郊二楼第三机房试验设备:Catalyst 2950-24(SW3) Cisco 2611(R2) Catalyst 3750 SERIES (带两个SD接口,S8----SW-2L) 真机(PC5、PC6)
2012-11-19 17:18:42 1006
转载 linux brctl 网桥设置
有五台主机。其中一台主机装有linux,安装了网桥模块,而且有四块物理网卡,分别连接同一网段的其他主机。我们希望其成为一个网桥,为其他四台主机(IP分别为192.168.1.2 ,192.168.1.3,192.168.1.4,192.168.1.5) 之间转发数据包。同时,为了方便管理,希望网桥能够有一个IP(192.168.1.1),那样管理员就可以在192.168.1.0/24网段内的主
2012-11-19 16:37:27 856
转载 linux做单臂路由实现trunk 使vlan之间通信
如果要使vlan之间进行通信,我们通常会使用三层交换机或者路由器子接口模式来做。Linux上关于VLAN与Cisco交换机中继连接,也是可以实现其互相之间的通信的。 环境:RHEL 5.2 最小化安装,物理网卡eth1,作为VLAN交换机连接的Trunk口连接到2960的GigabitEthernet0/1。而另外一张物理网卡eth0作为上行口,连接其他网络。 Cisco 2
2012-11-19 14:00:36 2775
转载 在linux路由上设置IP和MAC绑定
在有些系统中有这样的需求,希望内部网中的某几个IP地址连接互联网,而又希望这些IP地址不被非法用户盗用。可以通过下面的解决办法实现:1. 首先使用ipchains或者iptables来设定只允许合法的IP地址连出。对于合法IP建立IP/MAC捆绑。要讨论这个问题我们首先需要了解ARP协议的工作原理,ARP协议是地址解析协议(Address Resolution Protocol
2012-11-19 13:01:01 852
转载 linux网桥模式vlantrunk透传
首先使用vconfig创建vlan虚拟接口,并分别在两个接口上增加vlan100\vlan200\vlan300vconfig add eth0 100vconfig add eth0 200 vconfig add eth0 300vconfig add eth1 100vconfig add eth1 200vconfig add eth1 300启用vlan端口
2012-11-19 12:13:38 5465
网络工程师考前冲刺100题
2014-04-04
Introduction to Python Programming and Developing GUI Applications with PyQT
2012-09-15
Rapid GUI Programming with Python and Qt
2012-09-14
空空如也
TA创建的收藏夹 TA关注的收藏夹
TA关注的人