QCC512x Power Supplies

最新推荐文章于 2022-07-17 10:23:14 发布

芒果木有籽

最新推荐文章于 2022-07-17 10:23:14 发布

阅读量393

点赞数

分类专栏：蓝牙芯片文章标签： qcc512X power

本文链接：https://blog.csdn.net/jx__0570/article/details/90080287

版权

蓝牙芯片专栏收录该内容

9 篇文章 3 订阅 ¥29.90 ¥99.00

订阅专栏

超级会员免费看

QCC512x芯片在SYS_CTRL电压高于1.6V、VBAT超过2.8V或VCHG超过3.6V时开始启动。根据USB规范，当VBAT超过3.3V时，芯片从VBAT启动；如果VCHG超过3.6V且VBAT低于3.3V，芯片从VCHG启动；只有VCHG低于3.6V且VBAT低于2.6V时，芯片不会启动，以防过度放电。在无合适电源时，启动电路消耗约100μA直到启动刺激移除。

摘要由CSDN通过智能技术生成

Power supplies will start-up when:
SYS_CTRL goes high (from below 0.4V to above 1.6V)
Battery is attached (VBAT goes from below 0.4V to above 2.8V)
Charger is attached (VCHG does from below 0.4V to above 3.6V)

To meet requirements of USB specification, the chip decides which power input to boot from as follows:
When VBAT > 3.3V then battery is considered good and chip boots from VBAT
−In this case it does not matter what voltage is on VCHG
When VCHG > 3.6V (charger present) and VBAT < 3.3V then battery is considered weak and chip boots from VCHG
When VCHG < 3.6V (charger not present) and chip boots from VBAT as long as VBAT> 2.6V
When VCHG < 3.6V and VBAT < 2.6V then there is no good power source and the chip does not boot
−This is to prevent over-discharging the battery
−The start-up circuit will continue to consume ~100μA until boot stimulus is removed, but the chip will not start
All voltage thresholds are ±5%