WS2811 LED stm32 + PWM +DMA 验证可控制白光其他没有测试过 亮灭没有问题 20190326

//timer.c file

#include "timer.h"
/* Buffer that holds one complete DMA transmission
 * 
 * Ensure that this buffer is big enough to hold
 * all data bytes that need to be sent
 * 
 * The buffer size can be calculated as follows:
 * number of LEDs * 24 bytes + 42 bytes
 * 
 * This leaves us with a maximum string length of
 * (2^16 bytes per DMA stream - 42 bytes)/24 bytes per LED = 2728 LEDs
 */
#define TIM3_CCR3_Address 0x4000043c 	// physical memory address of Timer 3 CCR1 register
//#define TIM3_CCR1_Address 0x40000434	// physical memory address of Timer 3 CCR1 register
//#define TIM2_CCR4_Address 0x40000040
	
#define TIMING_ONE  25
#define TIMING_ZERO 11
 uint16_t LED_BYTE_Buffer[300];
 uint16_t testcount = 0;
  uint16_t testcount1 = 0;
//---------------------------------------------------------------//
 
void Timer2_init(void)
{
	TIM_TimeBaseInitTypeDef  TIM_TimeBaseStructure;
  TIM_OCInitTypeDef  TIM_OCInitStructure;
  GPIO_InitTypeDef GPIO_InitStructure;
  DMA_InitTypeDef DMA_InitStructure;
	
	RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA | RCC_APB2Periph_AFIO, ENABLE);
	/* GPIOA Configuration: TIM2 Channel 1 as alternate function push-pull */
	GPIO_InitStructure.GPIO_Pin = GPIO_Pin_0;
	GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
	GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
	GPIO_Init(GPIOA, &GPIO_InitStructure);
	
  
	RCC_APB1PeriphClockCmd(RCC_APB1Periph_TIM2, ENABLE);
	/* Compute the prescaler value */
	//PrescalerValue = (uint16_t) (SystemCoreClock / 24000000) - 1;
	/* Time base configuration */
	TIM_TimeBaseStructure.TIM_Period = 38; // 400kHz 
	TIM_TimeBaseStructure.TIM_Prescaler = 0;
	TIM_TimeBaseStructure.TIM_ClockDivision = 0;
	TIM_TimeBaseStructure.TIM_CounterMode = TIM_CounterMode_Up;
	TIM_TimeBaseInit(TIM2, &TIM_TimeBaseStructure);
 
	/* PWM1 Mode configuration: Channel1 */
	TIM_OCInitStructure.TIM_OCMode = TIM_OCMode_PWM2;
	TIM_OCInitStructure.TIM_OutputState = TIM_OutputState_Enable;
	TIM_OCInitStructure.TIM_OutputNState = TIM_OutputNState_Disable; // 失能输出比