How to collect ilom snapshot via CLI

Using the Oracle ILOM Snapshot Utility (CLI)
Before You Begin
■ To collect SP data using the Service Snapshot utility, you needthe Admin(a) role
enabled.
To run the Service Snapshot utility, follow these steps:

1. Log in to the Oracle ILOM CLI server SP.
2. Type the following commands:

 

    ->set /SP/diag/snapshot dataset= data
      ->set /SP/diag/snapshot dump_uri= URI

where data and URI areone of the following:
data  option
normal ：Specifies that Oracle ILOM, operating system, and hardwareinformation is tobe        collected.
FRUID  ：Available as of Oracle ILOM 3.0.3,requests Oracle ILOM to collect information about FRUs currentlyconfigured on your server in addition to the data collected by thenormal option.
full    ：Specifies that all datais to be collected (“full” collection).
                Note - Using this option might reset the running host.
• normal-logonly
• fruid-logonly
• full-logonly

URI  option
Any valid target directory location : Specifies the URI of thetarget directory. The URI format
is as follows:
                          protocol://username:password@host/directory
where protocol can be one of these transfer methods: SFTP orFTP.
For example, to store the snapshot information in the directorynamed data on the host, define the URI as follows:
ftp://joe:mypasswd@host_ip_address/data
The directory data is relative to the user’s login, so thedirectory would probably be /home/joe/data.

For your reference:
Japanese versionhttp://docs.oracle.com/cd/E19860-01/PDF/E23680-01.pdf (Pg.56)
English version  http://docs.oracle.com/cd/E19860-01/E21449/E21449.pdf (Pg.57)