RK3568-B2-ANDROID11-VGA

原理图

经原理图可知由芯片将EDP转成VGA-out

第一步：万用表测量和设置电源位使芯片供电正常

第二步：添加DTS-EDP部分（将HDMI关闭）

路径： \kernel\arch\arm64\boot\dts\rockchip\rk3568-evb.dtsi

	edp_panel: edp-panel {
		compatible = "simple-panel";
		status = "okay";  //disabled or okay
//	power-supply = <&vcc3v3_lcd_edp>;
	enable-gpios = <&gpio0 RK_PC4 GPIO_ACTIVE_HIGH>;
		prepare-delay-ms = <201>;
		enable-delay-ms = <201>;
		backlight = <&backlight>;
	display-timings {
	native-mode = <&timing0>;

	timing0: timing0 {
				
                clock-frequency = <140000000>;
                hactive = <1920>;
                vactive = <1080>;
                hfront-porch = <80>;
                hsync-len = <20>;
                hback-porch = <80>;
                vfront-porch = <12>;
                vsync-len = <24>;
                vback-porch = <12>;
                hsync-active = <0>;
                vsync-active = <0>;
                de-active = <0>;
                pixelclk-active = <0>;
	    };
	};
		ports {
			panel_in_edp: endpoint {
				remote-endpoint = <&edp_out_panel>;
			};
		};
	};
};

&edp {
    status = "okay"; //disabled or okay
    hpd-gpios = <&gpio0 RK_PC0 GPIO_ACTIVE_HIGH>;
    force-hpd;

    ports {
        edp_out: port@1 {
            reg = <1>;
            #address-cells = <1>;
            #size-cells = <0>;

            edp_out_panel: endpoint@0 {
                reg = <0>;
                remote-endpoint = <&panel_in_edp>;
            };
        };
    };
};


&route_edp {
	status = "okay"; //disabled or okay
	connect = <&vp0_out_edp>;
};
&edp_phy {
	status = "okay"; //disabled or okay
};
&edp_in_vp0 {
	status = "disabled"; //disabled or okay
};

&edp_in_vp1 {
	status = "disabled";
};

    //这里并未用到
    vcc3v3_lcd_edp: vcc3v3-lcd-edp {
        compatible = "regulator-fixed";
        gpio = <&gpio1 RK_PB1 GPIO_ACTIVE_HIGH>;
        enable-active-high;
        regulator-name = "vcc3v3_lcd_edp";
        regulator-boot-on;
        regulator-state-mem {
        regulator-off-in-suspend;
        };
	};

NAME	GPIO	GPIO_ACTIVE
vcc3v3_lcd_edp (LCD_EN)	GPIO1_B1	GPIO_ACTIVE_HIGH
enable-gpios(BL_EN)	GPIO0_C4	GPIO_ACTIVE_HIGH
hpd-gpios(EDP_HPD)	GPIO0_C0	GPIO_ACTIVE_HIGH