iw-3.7命令

# iw
Usage:  iw [options] command
Options:
        --debug      enable netlink debugging
        --version    show version (3.10)
Commands:
        help [command]
        event [-t] [-r] [-f]
        list
        phy
        commands
        features
        phy <phyname> info
        dev <devname> interface add <name> type <type> [mesh_id <meshid>] [4addr on|off] [flags <flag>*]
        phy <phyname> interface add <name> type <type> [mesh_id <meshid>] [4addr on|off] [flags <flag>*]
        dev <devname> del
        dev <devname> info
        dev
        dev <devname> ibss join <SSID> <freq in MHz> [HT20|HT40+|HT40-|NOHT] [fixed-freq] [<fixed bssid>] [beacon-interval <TU>] [basic-rates <rate in Mbps,rate2,...>] [mcast-rate <rate in Mbps>] [key d:0:abcde]
        dev <devname> ibss leave
        dev <devname> station dump
        dev <devname> station set <MAC address> mesh_power_mode <active|light|deep>
        dev <devname> station set <MAC address> vlan <ifindex>
        dev <devname> station set <MAC address> plink_action <open|block>
        dev <devname> station del <MAC address>
        dev <devname> station get <MAC address>
        dev <devname> survey dump
        dev <devname> mesh leave
        dev <devname> mesh join <mesh ID> [mcast-rate <rate in Mbps>] [beacon-interval <time in TUs>] [dtim-period <value>] [vendor_sync on|off] [<param>=<value>]*
        dev <devname> mpath dump
        dev <devname> mpath set <destination MAC address> next_hop <next hop MAC address>
        dev <devname> mpath new <destination MAC address> next_hop <next hop MAC address>
        dev <devname> mpath del <MAC address>
        dev <devname> mpath get <MAC address>
        dev <devname> scan [-u] [freq <freq>*] [ies <hex as 00:11:..>] [lowpri,flush,ap-force] [ssid <ssid>*|passive]
        dev <devname> scan trigger [freq <freq>*] [ies <hex as 00:11:..>] [lowpri,flush,ap-force] [ssid <ssid>*|passive]
        dev <devname> scan dump [-u]
        reg get
        reg set <ISO/IEC 3166-1 alpha2>
        dev <devname> disconnect
        dev <devname> connect [-w] <SSID> [<freq in MHz>] [<bssid>] [key 0:abcde d:1:6162636465]
        dev <devname> auth <SSID> <bssid> <type:open|shared> <freq in MHz> [key 0:abcde d:1:6162636465]
        dev <devname> link
        dev <devname> offchannel <freq> <duration>
        dev <devname> cqm rssi <threshold|off> [<hysteresis>]
        phy <phyname> wowlan show
        phy <phyname> wowlan disable
        phy <phyname> wowlan enable [any] [disconnect] [magic-packet] [gtk-rekey-failure] [eap-identity-request] [4way-handshake] [rfkill-release] [tcp <config-file>] [patterns [offset1+]<pattern1> ...]
        dev <devname> roc start <freq> <time in ms>
        wdev <idx> p2p stop
        wdev <idx> p2p start
        dev <devname> get mesh_param [<param>]
        dev <devname> get power_save <param>
        phy <phyname> set antenna <bitmap> | all | <tx bitmap> <rx bitmap>
        dev <devname> set txpower <auto|fixed|limit> [<tx power in mBm>]
        phy <phyname> set txpower <auto|fixed|limit> [<tx power in mBm>]
        phy <phyname> set distance <distance>
        phy <phyname> set coverage <coverage class>
        phy <phyname> set netns <pid>
        phy <phyname> set rts <rts threshold|off>
        phy <phyname> set frag <fragmentation threshold|off>
        dev <devname> set channel <channel> [HT20|HT40+|HT40-]
        phy <phyname> set channel <channel> [HT20|HT40+|HT40-]
        dev <devname> set freq <freq> [HT20|HT40+|HT40-]
        dev <devname> set freq <control freq> [20|40|80|80+80|160] [<center freq 1>] [<center freq 2>]
        phy <phyname> set freq <freq> [HT20|HT40+|HT40-]
        phy <phyname> set name <new name>
        dev <devname> set mcast_rate <rate in Mbps>
        dev <devname> set peer <MAC address>
        dev <devname> set noack_map <map>
        dev <devname> set 4addr <on|off>
        dev <devname> set type <type>
        dev <devname> set meshid <meshid>
        dev <devname> set monitor <flag>*
        dev <devname> set mesh_param <param>=<value> [<param>=<value>]*
        dev <devname> set power_save <on|off>

        dev <devname> set bitrates [legacy-<2.4|5> <legacy rate in Mbps>*] [mcs-<2.4|5> <MCS index>*]

扫描：

iw dev wlan0 scan