使用“nmcli”命令管理和配置网络

使用ip  link 命令找到网络接口名称

[student@workstation ~]$ ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP mode DEFAULT group default qlen 1000
    link/ether 52:54:00:00:fa:09 brd ff:ff:ff:ff:ff:ff
3: virbr0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN mode DEFAULT group default qlen 1000
    link/ether 52:54:00:b5:99:cf brd ff:ff:ff:ff:ff:ff
4: virbr0-nic: <BROADCAST,MULTICAST> mtu 1500 qdisc fq_codel master virbr0 state DOWN mode DEFAULT group default qlen 1000
    link/ether 52:54:00:b5:99:cf brd ff:ff:ff:ff:ff:ff

显示eth0设备的设置

 为eth0增加新连接

 sudo nmcli con add con-name "new-connection" ifname eth0 type ethernet

为“new-connection”设置网络

  ip地址：172.25.0.25/24

  默认网关：172.25.0.254

  DNS服务器：172.25.0.254

nmcli con mod "new-connection" ipv4.method manual ipv4.address 172.25.0.25/24 \
ipv4.gateway 172.25.0.254 ipv4.dns 172.25.0.254 

激活连接

nmcli con up "new-connection"