HDLBits刷题_Verilog Language_Always case

Case statements in Verilog are nearly equivalent to a sequence of if-elseif-else that compares one expression to a list of others. Its syntax and functionality differs from the switch statement in C.

always @(*) begin     // This is a combinational circuit
    case (in)
      1'b1: begin 
               out = 1'b1;  // begin-end if >1 statement
            end
      1'b0: out = 1'b0;
      default: out = 1'bx;
    endcase
end

• The case statement begins with case and each "case item" ends with a colon. There is no "switch".
• Each case item can execute exactly one statement. This makes the "break" used in C unnecessary. But this means that if you need more than one statement, you must use begin ... end.
• Duplicate (and partially overlapping) case items are permitted. The first one that matches is used. C does not allow duplicate case items.

A bit of practice

Case statements are more convenient than if statements if there are a large number of cases. So, in this exercise, create a 6-to-1 multiplexer. When sel is between 0 and 5, choose the corresponding data input. Otherwise, output 0. The data inputs and outputs are all 4 bits wide.

Be careful of inferring latches (See.always_if2)

// synthesis verilog_input_version verilog_2001
module top_module ( 
    input [2:0] sel, 
    input [3:0] data0,
    input [3:0] data1,
    input [3:0] data2,
    input [3:0] data3,
    input [3:0] data4,
    input [3:0] data5,
    output reg [3:0] out   );//

    always@(*) begin  // This is a combinational circuit
        case(sel)
            3'b000:out = data0;
            3'b001:out = data1;
            3'b010:out = data2;
            3'b011:out = data3;
            3'b100:out = data4;
            3'b101:out = data5;
           default: out = 0;
        endcase
    end

endmodule