首先给各个路由器配IP–以R1为例还有缺省
Interface IP Address/Mask Physical Protocol
GigabitEthernet0/0/0 16.1.1.1/24 up up
GigabitEthernet0/0/1 61.1.1.1/24 up up
GigabitEthernet0/0/2 unassigned down down
LoopBack0 1.1.1.1/24 up up(s)
NULL0 unassigned up up(s)
Tunnel0/0/0 10.1.1.1/24 up up
Tunnel0/0/1 20.1.1.1/24 up up
0.0.0.0/0 Static 60 0 RD 16.1.1.2 GigabitEthernet
0/0/0
Static 60 0 RD 61.1.1.2 GigabitEthernet
0/0/1
测试公网是否通
R1和R2R3为星型结构,以R1为站点
R1的配置为
interface Tunnel0/0/0
ip address 10.1.1.1 255.255.255.0
tunnel-protocol gre p2mp
source 16.1.1.1
ospf network-type broadcast
nhrp entry multicast dynamic
nhrp network-id 100
分支的配置为
interface Tunnel0/0/0
ip address 10.1.1.2 255.255.255.0
tunnel-protocol gre p2mp
source GigabitEthernet0/0/0
ospf network-type broadcast
ospf dr-priority 0
nhrp network-id 100
nhrp entry 10.1.1.1 16.1.1.1 register
R1 R4 R5为全连结构
配置为:
R1
interface Tunnel0/0/1
ip address 20.1.1.1 255.255.255.0
tunnel-protocol gre p2mp
source 61.1.1.1
ospf network-type broadcast
nhrp entry multicast dynamic
R4
interface Tunnel0/0/0
ip address 20.1.1.4 255.255.255.0
tunnel-protocol gre p2mp
source 46.1.1.1
ospf network-type broadcast
nhrp entry multicast dynamic
nhrp entry 20.1.1.1 61.1.1.1 register
R5
interface Tunnel0/0/0
ip address 20.1.1.5 255.255.255.0
tunnel-protocol gre p2mp
source 56.1.1.1
ospf network-type broadcast
nhrp entry multicast dynamic
nhrp entry 20.1.1.1 61.1.1.1 register
nhrp entry 20.1.1.4 46.1.1.1 register
进行OSPF配置
R1为例
ospf 1 router-id 1.1.1.1
area 0.0.0.0
network 1.1.1.1 0.0.0.0
network 10.1.1.0 0.0.0.255
network 20.1.1.1 0.0.0.0
切换ospf网络类型
ospf network-type broadcast
测试