锐捷网络实训二(VLAN Access口 Trunk口)

实训项目二

任务清单

基础配置

根据实训项目 2-拓扑图和实训项目 2-地址规划表上要求，为每一个PC配置IP地址。

VLAN配置

根据实训项目 2-拓扑图和实训项目 2-地址规划表上要求，在交换机上把VLAN划分到对应的接口上，并且更改交换机与交换机相连接口的模式。

设备名称	端口号	IP地址	VLAN
VPC1	Eth0	192.168.47.1/24	VLAN10
VPC2	Eth0	192.168.48.2/24	VLAN20
VPC3	Eth0	192.168.48.3/24	VLAN20
VPC4	Eth0	192.168.47.4/24	VLAN10
SW1	G0/0	无	Trunk
SW1	G0/1	无	VLAN10
SW1	G0/2	无	VLAN20
SW2	G0/0	无	Trunk
SW2	G0/1	无	VLAN20
SW2	G0/2	无	VLAN10

下面是每个设备的配置和配置验证截图，一般第一张是配置，有"show"开始为验证截图。最后有一个验证拓扑图各功能ping通的验证。

pc1

VPCS> ip 192.168.47.1 24 192.168.47.254
Checking for duplicate address...
VPCS : 192.168.47.1 255.255.255.0 gateway 192.168.47.254

VPCS> show ip

NAME        : VPCS[1]
IP/MASK     : 192.168.47.1/24
GATEWAY     : 192.168.47.254
DNS         : 
MAC         : 00:50:79:66:68:0f
LPORT       : 20000
RHOST:PORT  : 127.0.0.1:30000
MTU         : 1500

VPCS> 

pc2

VPCS> ip 192.168.48.2 24 192.168.48.254
Checking for duplicate address...
VPCS : 192.168.48.2 255.255.255.0 gateway 192.168.48.254

VPCS> show ip

NAME        : VPCS[1]
IP/MASK     : 192.168.48.2/24
GATEWAY     : 192.168.48.254
DNS         : 
MAC         : 00:50:79:66:68:10
LPORT       : 20000
RHOST:PORT  : 127.0.0.1:30000
MTU         : 1500

VPCS> 

pc3

VPCS> ip 192.168.48.3 24 192.168.48.254
Checking for duplicate address...
VPCS : 192.168.48.3 255.255.255.0 gateway 192.168.48.254

VPCS> show ip

NAME        : VPCS[1]
IP/MASK     : 192.168.48.3/24
GATEWAY     : 192.168.48.254
DNS         : 
MAC         : 00:50:79:66:68:11
LPORT       : 20000
RHOST:PORT  : 127.0.0.1:30000
MTU         : 1500

VPCS> 

pc4

VPCS> ip 192.168.47.4 24 192.168.47.254
Checking for duplicate address...
VPCS : 192.168.47.4 255.255.255.0 gateway 192.168.47.254

VPCS> show ip

NAME        : VPCS[1]
IP/MASK     : 192.168.47.4/24
GATEWAY     : 192.168.47.254
DNS         : 
MAC         : 00:50:79:66:68:12
LPORT       : 20000
RHOST:PORT  : 127.0.0.1:30000
MTU         : 1500

VPCS> 

 SW1

Ruijie>en
Password:******
User's password is too weak. Please change the password!
Ruijie#conf t
Enter configuration commands, one per line.  End with CNTL/Z.

Ruijie(config)#vlan 10
Ruijie(config-vlan)#vlan 20    //添加VLAN10，VLAN20
Ruijie(config-vlan)#exit

Ruijie(config)#int g0/0    //进入G0/0口
Ruijie(config-if-GigabitEthernet 0/0)#switchport mode trunk //设置为Trunk口

Ruijie(config-if-GigabitEthernet 0/0)#int g0/1
Ruijie(config-if-GigabitEthernet 0/1)#switchport mode access //设置为access口
Ruijie(config-if-GigabitEthernet 0/1)#switchport access vlan 10 //设置为vlan10

Ruijie(config-if-GigabitEthernet 0/1)#int g0/2
Ruijie(config-if-GigabitEthernet 0/2)#switchport mode access //设置为access口
Ruijie(config-if-GigabitEthernet 0/2)#switchport access vlan 20 //设置为vlan20

Ruijie(config-if-GigabitEthernet 0/2)#exit
Ruijie(config)#hostname SW1
SW1(config)#exit
SW1#wr

SW1#show vlan
VLAN       Name                             Status    Ports
---------- -------------------------------- --------- -----------------------------------
         1 VLAN0001                         STATIC    Gi0/0, Gi0/3, Gi0/4, Gi0/5            
                                                      Gi0/6, Gi0/7, Gi0/8                   
        10 VLAN0010                         STATIC    Gi0/0, Gi0/1                          
        20 VLAN0020                         STATIC    Gi0/0, Gi0/2                          

SW2

Ruijie>en
Password:******
User's password is too weak. Please change the password!
Ruijie#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Ruijie(config)#hostname SW2

SW2(config)#vlan 10
SW2(config-vlan)#vlan 20

SW2(config-vlan)#int g0/0
SW2(config-if-GigabitEthernet 0/0)#switchport mode trunk 

SW2(config-if-GigabitEthernet 0/0)#int g0/1
SW2(config-if-GigabitEthernet 0/1)#switchport mode access 
SW2(config-if-GigabitEthernet 0/1)#switchport access vlan 20

SW2(config-if-GigabitEthernet 0/1)#int g0/2
SW2(config-if-GigabitEthernet 0/2)#switchport mode access 
SW2(config-if-GigabitEthernet 0/2)#switchport access vlan 10

SW2(config-if-GigabitEthernet 0/2)#exit
SW2(config)#exit
SW2#wr

SW2#show vlan
VLAN       Name                             Status    Ports
---------- -------------------------------- --------- -----------------------------------
         1 VLAN0001                         STATIC    Gi0/0, Gi0/3, Gi0/4, Gi0/5            
                                                      Gi0/6, Gi0/7, Gi0/8                   
        10 VLAN0010                         STATIC    Gi0/0, Gi0/2                          
        20 VLAN0020                         STATIC    Gi0/0, Gi0/1                          

验证截图

VPCS> show ip

NAME        : VPCS[1]
IP/MASK     : 192.168.47.1/24
GATEWAY     : 192.168.47.254
DNS         : 
MAC         : 00:50:79:66:68:0f
LPORT       : 20000
RHOST:PORT  : 127.0.0.1:30000
MTU         : 1500

VPCS> ping 192.168.47.4

84 bytes from 192.168.47.4 icmp_seq=1 ttl=64 time=3.046 ms
84 bytes from 192.168.47.4 icmp_seq=2 ttl=64 time=2.459 ms
84 bytes from 192.168.47.4 icmp_seq=3 ttl=64 time=2.569 ms
84 bytes from 192.168.47.4 icmp_seq=4 ttl=64 time=2.581 ms
84 bytes from 192.168.47.4 icmp_seq=5 ttl=64 time=2.221 ms

VPCS> 

VPCS> show ip

NAME        : VPCS[1]
IP/MASK     : 192.168.48.2/24
GATEWAY     : 192.168.48.254
DNS         : 
MAC         : 00:50:79:66:68:10
LPORT       : 20000
RHOST:PORT  : 127.0.0.1:30000
MTU         : 1500

VPCS> ping 192.168.48.3

84 bytes from 192.168.48.3 icmp_seq=1 ttl=64 time=2.028 ms
84 bytes from 192.168.48.3 icmp_seq=2 ttl=64 time=2.208 ms
84 bytes from 192.168.48.3 icmp_seq=3 ttl=64 time=3.009 ms
84 bytes from 192.168.48.3 icmp_seq=4 ttl=64 time=2.236 ms
84 bytes from 192.168.48.3 icmp_seq=5 ttl=64 time=1.906 ms

VPCS>