stm32f407单片机底层应用程序_usart4

usart4.c

#include "usart4.h"




void My_USART4_Init(USART_TypeDef* USARTx,u32 bound)
{
	GPIO_InitTypeDef     GPIO_InitStructure;
	USART_InitTypeDef   USART_InitStructure;
	NVIC_InitTypeDef     NVIC_InitStructure;
	
	RCC_APB1PeriphClockCmd(RCC_APB1Periph_UART4 , ENABLE); 		//for USART2, USART3, UART4 or UART5.	
	RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOA, ENABLE);

		
	//GPIO
	GPIO_PinAFConfig(GPIOA, GPIO_PinSource0, GPIO_AF_UART4);
	GPIO_PinAFConfig(GPIOA, GPIO_PinSource1, GPIO_AF_UART4);   
		
	GPIO_InitStructure.GPIO_Pin = GPIO_Pin_0|GPIO_Pin_1; 
	GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF;
	GPIO_InitStructure.GPIO_OType = GPIO_OType_PP;
	GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_UP;
	GPIO_InitStructure.GPIO_Speed = GPIO_Speed_100MHz;
	GPIO_Init(GPIOA,&GPIO_InitStructure);
			
	//USART
	USART_InitStructure.USART_BaudRate = bound;
	USART_InitStructure.USART_WordLength = USART_WordLength_8b;
	USART_InitStructure.USART_StopBits = USART_StopBits_1;
	USART_InitStructure.USART_Parity = USART_Parity_No;
	USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
	USART_InitStructure.USART_Mode =  USART_Mode_Rx | USART_Mode_Tx;	
	USART_Init(USARTx,&USART_InitStructure);
	

	
	//NVIC
	NVIC_InitStructure.NVIC_IRQChannel = UART4_IRQn;
	NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 0;
	NVIC_InitStructure.NVIC_IRQChannelSubPriority = 0;
	NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;
	NVIC_Init(&NVIC_InitStructure);
	
		
	USART_DMACmd(USARTx, USART_DMAReq_Rx, ENABLE);	
	USART_DMACmd(USARTx, USART_DMAReq_Tx, ENABLE);	
	USART_ITConfig(USARTx, USART_IT_IDLE, ENABLE); 
	
	USART_Cmd(USARTx,ENABLE);	

}

usart4.h

#ifndef  __USART4_H
#define  __USART4_H
#include "sys.h"



void My_USART4_Init(USART_TypeDef* USARTx,u32 bound);



#endif