IMX577-AACK-C Sony索尼图像传感器COMS

The IMX577-AACK-C is a diagonal 7.857 mm (Type 1/2.3) 12.3 Mega-pixel CMOS active pixel type stacked image

sensor with a square pixel array. It adopts Sony’s Stacked CMOS Image Sensor technology to achieve high speed

image capturing by column parallel A/D converter circuits and high sensitivity and low noise image (comparing with

conventional CMOS image sensor) through the backside illuminated imaging pixel structure. R, G, and B pigment

primary color mosaic filter is employed. It equips an electronic shutter with variable integration time. It operates with

three power supply voltages: analog 2.8 V, digital 1.05 V and 1.8 V for input/output interface and achieves low power

consumption.

In addition, this product is designed for use in consumer use camcorder. When using this for another application,

Sony Semiconductor Solutions Corporation does not guarantee the quality and reliability of product.

Therefore, don't use this for applications other than consumer use camcorder.

In addition, individual specification change cannot be supported because this is a standard product.

Consult your Sony Semiconductor Solutions Corporation sales representative if you have any questions.

◆ Back-illuminated and stacked CMOS image sensor

◆ Digital Overlap High Dynamic Range (DOL-HDR) mode with raw data output.

◆ High signal to noise ratio (SNR).

◆ Full resolution @60 frame/s (Normal), 4K2K @60 frame/s (Normal), 1080p @240 frame/s

Full resolution @40 frame/s (12 bit Normal), Full resolution @30 frame/s (DOL-HDR, 2 frame)

◆ Output video format of RAW12/10/8, COMP8.

◆ Power Save Mode with MIPI ULPS operation

◆ Pixel binning readout and V sub-sampling function.

◆ Independent flipping and mirroring.

◆ Input clock frequency 6 to 27 MHz

◆ CSI-2 serial data output (MIPI 2lane/4lane, Max. 2.1 Gbps/lane, D-PHY spec. ver. 1.2 compliant)

◆ 2-wire serial communication.

◆ Two PLLs for independent clock generation for pixel control and data output interface.

◆ Defect Pixel Correction (DPC)

◆ Ambient Light Sensor (ALS)

◆ Fast mode transition. (on the fly)

◆ Dual sensor synchronization operation (Multi camera compatible )

◆ 7 kbit of OTP ROM for users.

◆ Built-in temperature sensor

◆ 10-bit/12-bit A/D conversion on chip

◆ Horizontal Low Power Analog Cropping

◆ Window Scanning mode

◆ 92-pin high-precision ceramic package

Sony Semiconductor Solutions Corporation reserves the right to change products and specifications without prior notice.

This information does not convey any license by any implication or otherwise under any patents or other right.

Application circuits shown, if any, are typical examples illustrating the operation of the devices. Sony Semiconductor Solutions

Corporation cannot assume responsibility for any problems arising out of the use of these circuits.​​​​​​​

Device Structure

◆ CMOS image sensor

◆ Image size

: Diagonal 7.857 mm (Type 1/2.3)

◆ Total number of pixels

: 4072 (H) × 3176 (V) approx. 12.93 M pixels

◆ Number of effective pixels

: 4072 (H) × 3064 (V) approx. 12.47 M pixels

◆ Number of active pixels

: 4056 (H) × 3040 (V) approx. 12.33 M pixels

◆ Chip size

: 7.564 mm (H) × 5.476 mm (V)

◆ Unit cell size

: 1.55 µm (H) × 1.55 µm (V)

◆ Substrate material

: Silicon

Note) The capacitor values and parts count used for decoupling of power supply lines in this diagram are

determined only with Sony Semiconductor Solutions Corporation’s testing environment. The capacitor values

and/or parts count for power line decoupling may have to be reviewed and optimized by each manufacture

depending on their design.

Note) If you need combined with the OIS, There is a need to change the connection of the pins below.

TEST1/CSBC, TEST2/SCKC, TEST3/SDIC, GYINT, SCSB, SCK, SDO, SDI

See software reference manual for details.

IMX577-AACK-C can connect with OIS controller using SPI bypass function. When the bypass mode set to enable,

OIS controller can get the gyro data through IMX577-AACK-C. Each terminal also requires 1.8 V I/O voltage level

when connect with OIS controller and gyro LSI. See software reference manual for details.​​​​​​​

System Outline

IMX577-AACK-C is a CMOS active pixel type image sensor which adopts the Sony’s Stacked CMOS Image Sensor

technology to achieve high sensitivity, low noise, and high speed image capturing. It is embedded with backside

illuminated imaging pixel, low noise analog amplifier, column parallel A/D converters which enables high speed

capturing, digital amplifier, image binning circuit, timing control circuit for imaging size and frame rate, CSI-2 image

data high speed serial interface, PLL oscillator, and serial communication interface to control these functions. When

Gyro function is enabled, Gyro control block in IMX577-AACK-C is processed based on the input data from Gyro IC.

Several additional image processing functions and peripheral circuits are also included for easy system optimization

by the users.

A onetime programmable memory is embedded in the chip for storing the user data. It has 7 kbit for users,

16 kbit as a whole.