Use Memory Layout from Target Dialog

       Use Memory Layout from Target Dialog

            When enabled, µVision creates a linker scatter file from the memory information supplied in the dialogs Target and Properties. When disabled, then the 

            R/O Base, R/W Base, and Scatter File can be set manually. The scatter file defines the memory layout and allows assigning modules to specific memory areas.

refer：

Target (MDK-ARM)

Home » Dialogs » Project » Options » Target » Target (MDK-ARM)

The window Options for Target - Target allows configuring the device and application for using an operating system, set the code generation options, and specifying the memory areas of the device.

Xtal (MHz)

Specifies the XTAL frequency of your device. XTAL is used to configure the debugger and Flash programmer. Note that XTAL reflects the main oscillator externally connected to the device. 

Operating System

Select the RTX Kernel which adds the correct RTX library and enables kernel aware debugging.

System-Viewer File (.Sfr):

Specifies the file for debugging peripheral registers with the System Viewer. For details refer toAdding System Viewer Windows.

Code Generation

Select ARM-Mode or Thumb-Mode for the application.

Use Cross-Module Optimization enables the linker feedback file that allows further code optimizations.

Select usage for the Floating Point Hardware on devices that have a Vector Floating Point (VFP) co-processor: