root@o-pi-z:/home/zc# h3consumption -p
Active settings:
cpu 1200 mhz allowed, 1200 mhz possible, 4 cores active
dram 408 mhz
hdmi/gpu off
usb ports active
eth0 100Mb/s/Full, Link: yes
wlan0 IEEE 802.11bgn ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
上面那个是我的zero目前的设置
现在armbian提供了一个工具可以对CPU和GPU的情况进行调整
h3consumption 这个在目前4.13的主线下无法使用,3.4的BPM内核可以用
关闭GPU 就是 h3consumption -g off
还可以关闭核心,但是关闭wlan那个貌似意义不大 不如ifconfig wlan0 down........
h3consumption -h
Usage: h3consumption [-h/-H] [-p] [-g on|off] [-m max_cpufreq] [-c 1|2|3|4]
[-d dram_freq] [-D dram_freq] [-u on|off] [-e on|off|fast]
############################################################################
This tool allows to adjust a few consumption relevant settings of your
H3 device. Use the following switches
-h|-H displays help or verbose help text
-p print currently active settings
-g on|off disables GPU/HDMI for headless use
-m max_cpufreq adjusts maximum allowed cpu clockspeed (mhz)
-c 1|2|3|4 activate only this count of CPU cores
-d dram_freq adjusts dram clockspeed (408 - 624 mhz)
-D dram_freq like -d but as low as 132 mhz possible (experimental!)
-u on|off enables/disabled all USB ports
-e on|off|fast enables/disables Ethernet, the fast switch
forces 100 mbits/sec negotiation on gigabit devices
-w on|off enables/disables Wi-Fi powermanagement when interface
supports this and is controlled by network-manager