FCC-5G基站测试标准解读-占用带宽（OBW）

最新推荐文章于 2024-05-27 14:21:50 发布

爱学习的man

最新推荐文章于 2024-05-27 14:21:50 发布

阅读量527

点赞数

分类专栏：原创文章标签： 5G Powered by 金山文档

本文链接：https://blog.csdn.net/qq_20799821/article/details/128911837

版权

原创专栏收录该内容

9 篇文章 0 订阅

订阅专栏

文章详细描述了按照FCCCFR47Part2和Part27的相关条款，以及RSS-GEN的规定，对设备进行最大功率传输测试的过程。使用频谱分析仪测量26dB和99%占用带宽，设置合适的中心频率、频率跨度、IF滤波器带宽和VBW，确保信号线性操作并报告测量带宽。

摘要由CSDN通过智能技术生成

参考标准

FCC CFR 47 Part2, Clause 2.1049

FCC CFR 47 Part27, Clause 27.53

RSS-GEN, Clause6.7

测试方法

The EUT was set to transmit at maximum power and testing was carriedout on bottom, middle and top channels.Using the OccupiedBandwidth measurement functionin the spectrum analyzer, the26dB bandwidth was measured in accordance with FCC KDB 971168 D01. In addition,measurements of 99% occupied bandwidths were made in accordance with RSS-GEN.

The measurementmethod is from ANSI C63.26:

Thespectrum analyzer center frequency is set to the nominal EUT channel center frequency. The frequency span for thespectrum analyzer shall be set wide enough to capture all modulation productsincluding the emission skirts.

Thenominal IF filter bandwidth (3 dB RBW) shall be in the range of 1 to 5 % of theanticipated OBW, and the VBW shall be at least 3 times the RBW.

Setthe reference level of the instrument as required to keep the signal fromexceeding the maximum input mixer level for linear operation. In general, thepeak of the spectral envelope must be at least 10log (OBW / RBW) below thereference level.