Patran错误及修改方法学习记录

最近对实验柜做模态分析，记录一下初学patran遇到的一些错误，解决方法主要是从网上查找到的。

0.导入模型时一定要记得先转换英制至毫米制！

1.USER FATAL MESSAGE 9050(SEKRRS)

做模态分析，根据模态振型看哪里没有连接；

2.模态分析时，出现错误:

USER FATAL MESSAGE 4683 (LNNRIGL)

MASS MATRIX NEEDED FOR EIGENVALUE ANALYSIS

property未填密度;网格节点有的没连接上，导致载荷无法传递，检查节点连接（equivalence），或者是有重复节点；节点有的没合并，Equivlance。

3.USER FATAL MESSAGE 5289 (WRGMTS)

DEPENDENT DEGREE-OF-FREEDOM GRID ID =863 AND COMPONENT =1 APPEARS ON MORE THAN ONE MPC OR RIGID ELEMENT ENTRY.

独立/非独立节点互换

4.加mpc后分析出现错误警告：

Patran 2018 has found nodes for which both SPCs and dependent MPC relationships exist. Nastran will not accept such a specification.  The affected nodes have been placed in a group by the name of "BDF_WARNING_MPC_SPC_CONFL".  You may choose to proceed with your specified course of action provided that there are no other problems, or you may choose to bypass the job submission, if requested, and modify the database.  If you choose to proceed, the SPCs for the affected nodes will be omitted, thus creating an analysis deck that Nastran will accept, but which may not conform to your modeling specifications.

在有固定位移约束的节点添加MPC，且为非独立节点（这个错误犯得好蠢呀…）

5.模态分析

Fatal 4405

NO EIGENVECTORS COMPUTED FOR COMPONENT MODE SYNTHESIS OR SYSTEM SOLUTION.

提高模态频率计算范围，给的频率范围提取不到。

6.loadcase不能删除 工况问题

在anlysis中的subcase中先删除 然后再在loadcase中删除（待验证=，=）