【CH32V305FBP6】UART 配置

前言

使用 PB15 和 PA8 作为串口1引脚。

实现

硬件设计

TX: PB15
RX: PA8

软件设计

重映射

寄存器

    AFIO->PCFR1 &=~ (0X01<<2);
    AFIO->PCFR2 |=  (0X01<<26);

软件配置

/* debug.c */

void USART_Printf_Init(uint32_t baudrate)
{
    GPIO_InitTypeDef  GPIO_InitStructure;
    USART_InitTypeDef USART_InitStructure;

    RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1 | RCC_APB2Periph_GPIOB | RCC_APB2Periph_AFIO, ENABLE);

    AFIO->PCFR1 &=~ (0X01<<2);
    AFIO->PCFR2 |=  (0X01<<26);

    GPIO_InitStructure.GPIO_Pin = GPIO_Pin_15;
    GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
    GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
    GPIO_Init(GPIOB, &GPIO_InitStructure);

    USART_InitStructure.USART_BaudRate = baudrate;
    USART_InitStructure.USART_WordLength = USART_WordLength_8b;
    USART_InitStructure.USART_StopBits = USART_StopBits_1;
    USART_InitStructure.USART_Parity = USART_Parity_No;
    USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
    USART_InitStructure.USART_Mode = USART_Mode_Tx;

    USART_Init(USART1, &USART_InitStructure);
    USART_Cmd(USART1, ENABLE);
}