#define TIMER TIMER3
#define TIMER_CH TIMER_CH_2
#define RCC_TIMER RCU_TIMER3
#define TIMER_PORT GPIOB
#define TIMER_BG_PIN GPIO_PIN_8 //1:亮 0:不亮
/* Timer3_CH3 PWM输出 */
void Timer3_Init(void)
{
/* 使用SW下载,不使用JTAG下载,管脚用作其它功能 */
gpio_pin_remap_config(GPIO_SWJ_SWDPENABLE_REMAP, ENABLE);
rcu_periph_clock_enable(RCC_TIMER);
rcu_periph_clock_enable(RCU_GPIOB);
/* LCD_BG使用Timer3_CH3 PWM输出控制亮度(10kHz) */
gpio_init(TIMER_PORT,GPIO_MODE_AF_PP,GPIO_OSPEED_50MHZ,TIMER_BG_PIN);
timer_parameter_struct timer3_init;
timer_oc_parameter_struct timer3_ocintpara;
timer_deinit(TIMER);
/* TIMER3 configuration */
timer3_init.prescaler = 107;
timer3_init.alignedmode = TIMER_COUNTER_EDGE;
timer3_init.counterdirection = TIMER_COUNTER_UP;
timer3_init.period = 99; //10kHz
timer3_init.clockdivision = TIMER_CKDIV_DIV1;
timer3_init.repetitioncounter = 0;
timer_init(TIMER3,&timer3_init);
/* CH3 configuration in PWM mode */
timer3_ocintpara.outputstate = TIMER_CCX_ENABLE;
timer3_ocintpara.outputnstate = TIMER_CCXN_DISABLE;
timer3_ocintpara.ocpolarity = TIMER_OC_POLARITY_HIGH;
timer3_ocintpara.ocnpolarity = TIMER_OCN_POLARITY_HIGH;
timer3_ocintpara.ocidlestate = TIMER_OC_IDLE_STATE_LOW;
timer3_ocintpara.ocnidlestate = TIMER_OCN_IDLE_STATE_LOW;
timer_channel_output_config(TIMER,TIMER_CH,&timer3_ocintpara);
timer_primary_output_config(TIMER,ENABLE);
/* CH3 configuration in PWM mode0,duty cycle 30% */
timer_channel_output_pulse_value_config(TIMER,TIMER_CH,90);
timer_channel_output_mode_config(TIMER,TIMER_CH,TIMER_OC_MODE_PWM0);
timer_channel_output_shadow_config(TIMER,TIMER_CH,TIMER_OC_SHADOW_DISABLE);
/* auto-reload preload enable */
timer_auto_reload_shadow_enable(TIMER);
/* enable TIMER3 */
timer_enable(TIMER);
}
GD32F103定时器输出PWM
最新推荐文章于 2024-05-25 00:26:07 发布