stm32f4xx-DAC

一、数字模拟转换DAC

二、DAC

三、test、DAC输出->ADC输入

// STM_DAC
void STM_DAC_init(void)
{
	GPIO_InitTypeDef GPIO_InitStructure;
	DAC_InitTypeDef DAC_InitStructure;
	//使能PA的硬件时钟
	RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOA, ENABLE);

	//使能DAC的硬件时钟
	RCC_APB1PeriphClockCmd(RCC_APB1Periph_DAC, ENABLE);	
	
	//配置PA4的引脚为模拟信号引脚
	GPIO_InitStructure.GPIO_Pin = GPIO_Pin_4;
	GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AN;
	GPIO_InitStructure.GPIO_Speed = GPIO_Speed_100MHz;		//高速
	GPIO_InitStructure.GPIO_OType = GPIO_OType_PP;			//推挽输出，增加输出电流能力
	GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_NOPULL;
	GPIO_Init(GPIOA, &GPIO_InitStructure);

	//配置DAC相关的参数
	DAC_InitStructure.DAC_Trigger = DAC_Trigger_None;					//不需要脉冲触发工作
	DAC_InitStructure.DAC_WaveGeneration = DAC_WaveGeneration_None;		//不生成波形
	DAC_InitStructure.DAC_OutputBuffer = DAC_OutputBuffer_Enable;		//允许输出电压
	DAC_Init(DAC_Channel_1, &DAC_InitStructure);
	
	//使能DAC通道1工作
	DAC_Cmd(DAC_Channel_1, ENABLE);

}

int main(void)
{
    USART1_init(115200);
    uint16_t adc_val,adc_vol,sum,i;
	ADC1_CH5_init();
	STM_DAC_init();
	//dac通道1输出电压值1800*4095/3300
	DAC_SetChannel1Data(DAC_Align_12b_R, 1800*4095/3300);//12位右对齐数据格式设置DAC值
	//启动adc1的转换
	ADC_SoftwareStartConv(ADC1);
	while(1)
	{
		sum = 0;
		for(i = 0; i<1000; i++)
		{
			//等待ADC1转换完毕
			while(ADC_GetFlagStatus(ADC1, ADC_FLAG_EOC) == RESET);
			
			ADC_ClearFlag(ADC1, ADC_FLAG_EOC);
			//得到结果值
			adc_val = ADC_GetConversionValue(ADC1);
			
			//将结果值转换为电压值
			adc_vol = adc_val*3300/4095;
			
			sum+=adc_vol;
		}
		
		adc_vol = (sum/1000);	
		
		printf("adc_val = %dmv", adc_val);
		printf("adc_vol = %dmv\r\n", adc_vol);
		
		delay_ms(1000);
	}
}