ansys apdl建模案例1-----------杯子

这里没什么好讲的，主要是体会建模的思路及流程。

一、最终结果图

二、命令

/clear,start
/prep7
k,1,0,0,0		!创建关键点
k,2,0.0395,0,0
k,3,0.05,0.12,0
k,4,0.047,0.12,0
k,5,0.0367,0.003,0
k,6,0,0.003,0
lstr,1,2		!将关键点连成一条直线
lstr,2,3
lstr,3,4
lstr,4,5
lstr,5,6
lstr,6,1
lfillt,1,2,0.02	!线倒角
lfillt,4,5,0.017
al,all		!将所有线连接构成一个平面
vrotat,all,,,,,,1,6,360	!将面绕1,6关键点连成的轴线旋转360°生成体
k,31,0,0.103,0
k,32,0.078,0.103,0
k,33,0.078,0.046,0
k,34,0,0.0011,0
lstr,31,32
lstr,32,33
lstr,33,34
lfillt,54,55,0.013
lfillt,55,56,0.028
k,41,0,0.105,0.005
k,42,0,0.105,-0.005
k,43,0,0.101,-0.005
k,44,0,0.101,0.005
lstr,41,42
lstr,42,43
lstr,43,44
lstr,44,41
lfillt,59,60,0.001
lfillt,60,61,0.001
lfillt,61,62,0.001
lfillt,62,59,0.001
al,59,63,60,64,61,65,62,66	!将选择的线连接成为一个平面
vdrag,33,,,,,,54,57,55,58,56	!将面33沿着线54,57,55,58,56扫掠生成体
vsel,s,,,5,9,4	!选择编号为5和9的体
asel,s,,,4,28,24	!选择编号为4和28的面
vsba,all,all	!用选择的面来分割选择的体
allsel,all
vdele,10,,,1	!删除体
vdele,13,,,1
/pnum,volu,1	!打开实体编号显示
/number,1	!只显示颜色，不显示编号
/color,volu,yell,all	!将所有实体颜色改为黄色
/replot
finish