Statistic Wire详解

lmz:
从接受机可以引出数据线，这个数据线可以引出哪些数据呢？

bus receiver.bit error rate

This statistic represents the bit error rate among the bits of the packet which is completing arrival at the receiver channel.
This statistic may be collected as a coupled statistic.

误码率。
误码率的计算必须是在包被完整接收的时候才可以。

bus receiver.bit errors per packet

This statistic represents the number of bit errors within the packet completing arrival at the receiver channel.
This statistic may be collected as a coupled statistic.

误比特数。
相对于每个包而言。

bus receiver.busy

This statistic is a Boolean value (0.0 or 1.0) which represents whether any packets are currently being received or transmitted on a channel.
The ‘time average’ filter is recommended when viewing results.

布尔值(0.0或1.0)。
是否有包在信道上正在被传输或者被接收。

bus receiver.collision status

This statistic is a Boolean value (0.0 or 1.0) that reflects the collision of packets at the receiver channel.
The ‘time average’ filter is recommended when viewing results.

接收机可以判断包是否发生碰撞。
可以猜测，发生碰撞的包是不会被接收的。

bus receiver.packet loss ratio

This statistic is a Boolean value (0.0 or 1.0) that corresponds to the acceptance or rejection of a packet, respectively.
This statistic may be collected as a coupled statistic.

包是否被接收。
碰撞的包不会被接收。
丢失率和碰撞感觉是一个东西。

bus receiver.throughput (bits/sec)

This statistic represents the average number of bits successfully received or transmitted by the receiver or transmitter channel per unit time, in bits per second.
If collecting all values, please use the ‘time average’ filter when viewing results.

成功接收的或者传输的单位比特数。

bus receiver.throughput (packets/sec)

This statistic represents the average number of bits successfully received or transmitted by the receiver or transmitter channel per unit time, in bits per second.
If collecting all values, please use the ‘time average’ filter when viewing results.

bus receiver.utilization

This statistic represents a measure of the consumption to date of an available channel bandwidth, where a value of 100.0 would indicate full usage.
If collecting all values, please use the ‘time average’ filter when viewing results.

信道带宽的利用率。

tags:opnet