美赛数模论文之图

美赛数模论文之图

引用的文献数据所画的图：

    1、分阶段图的引入：

    First we study the …… (文献)，showing …… under the situation.

     分阶段图的引出：

    The compression process is divided into three(数字) phases, as shown in the figure:

    The first phase: …… deformation, according to ……; the second phase: …… deformation. The compression grows more slowly and reaches the maximum. The third phase: ……deformation: After compression reaches the maximum, the rate of deformation starts to fall. The unrecoverable deformation goes on increasing. (2003—65)

    2、引用已有的模型图：

     A model of flow rate for instant total failure is right triangular 【U.S. Army Corps of Engineers 1997】. (see Figure 1)(2005—53\54)

3、通过历史数据作图：

We validate our model by examining historical HIV rates from prenatal clinics in South Africa between 1995 and 2005(Figure 1). (2006—244)

    4、拟合的图形：

    Figure 1 shows the number of bags still left for the EDS to process at airport A after each minute in airport B, the results are similar. (2003—260)

自己根据计算所画的图：

1、为了…….(目的)，我们作了…….图。

To demonstrate better the change in flow rate with time when the breach begins t form, we plot over a shorter range of time in Figure 5. (2005—55)

We plot for values of from 6 to 13, in steps of 0.25, together with the best-fit quartic, in Figure 2 (2005—92)

2、根据数据拟合的图：

Fitting (式子) to the data in (表), we get the curve in Figure 1, for the function (公式). (2005—211)

 

We use the graph in Figure 1 to simulate the arrival of passengers. (2003—201)

 

The simulation model also generates system characteristics for the ETD machines at airport A. These results are shown in Figure 3. (2003—232)

3、根据取值不同画图：

We take 2001as the starting point, when total remaining oil was 1.1178bbl.We calculate the time to oil exhaustion under different cases: GDP growing at 10%, 5%, 3%,and 1%.(Figure 3)

For 10%, ...... ; for 5%,……;for 3%,……;for 1%,……. (2005—213\233)

4、用软件（如MATLAB）画图：

To solve the differential equations in our model, we use (the ODE45 numerical integrator) in MATLAB on (式子) to find the results in Figure 3.(2005—232)

    5、图形的改进：

Generally speaking, the shape of the target is not too irregular, so we choose five typical shapes of the targets in different sizes. In Figure 3a, we illustrate the maximum section of a typical bean-shaped target, whose maximum dimension is 35mm. Using the skeleton generation algorithm, we get corresponding skeleton shown in Figure 3b. Then we apply the GA-based shot placement algorithm, resulting in three shots for the target: one 14 mm helmet and two 8 mm helmets. The locations and sizes of the helmets in 2D are indicated in Figure 3c, while 3D shot placements are shown in Figure 4. (2003—130)

6、画示意图：

The irrigation order and position of sprinklers are presented in Figure 4. (2006—127)

This algorithm can be viewed in the flowchart in Figure 3.We define some of the objects found in the chart. (2006—164\165)