杰理之PWM硬件IO说明【篇】

除了开启上述的宏外，还需在board.c 添加PWM参数和PWM设备，如下代码所示（同时最多可以定义3个PWM设备，设备列表的设备名称可以自定义）

PWM频率最高为：LSB时钟/2，当PWM频率设置接近LSB时钟/2时，占空比也无效，设置频率高则占空比小数点point_bit应当设置为0

以下代码PWM0是正反转PWM选择，PWM1是普通定时器PWM选择方法。

//----------------------------------定义PWM设备的参数------------------------------------------//
//例如：PWM0
PWM_PLATFORM_DATA_BEGIN(pwm_data0)

    .port  = 0,
    .pwm_ch = PWMCH0_H | PWMCH0_L,//初始化可选多通道,如:PWMCH0_H | PWMCH0_L | PWMCH1_H ... | PWMCH7_H | PWMCH7_L | PWM_TIMER2_OPCH2 | PWM_TIMER3_OPCH3 ,
    .freq   = 1000,//频率
    .duty   = 50,//占空比
    .point_bit = 0,//根据point_bit值调节占空比小数点精度位: 0<freq<=4K,point_bit=2;4K<freq<=40K,point_bit=1; freq>40K,point_bit=0;
PWM_PLATFORM_DATA_END()

//例如：PWM1
PWM_PLATFORM_DATA_BEGIN(pwm_data1)

    .port  = IO_PORTA_03,//选择定时器的TIMER PWM任意IO，pwm_ch加上PWM_TIMER3_OPCH3或PWM_TIMER2_OPCH2有效,只支持2个PWM,占用output_channel2/3，其他外设使用output_channel需留意
    .pwm_ch = PWM_TIMER2_OPCH2,//初始化可选多通道,如:PWMCH0_H | PWMCH0_L | PWMCH1_H ... | PWMCH7_H | PWMCH7_L | PWM_TIMER2_OPCH2 | PWM_TIMER3_OPCH3 ,
    .freq   = 1000,//频率
    .duty   = 50,//占空比
    .point_bit = 0,//根据point_bit值调节占空比小数点精度位: 0<freq<=4K,point_bit=2;4K<freq<=40K,point_bit=1; freq>40K,point_bit=0;
PWM_PLATFORM_DATA_END()

//----------------------------------设备列表添加PWM设备------------------------------------------//
REGISTER_DEVICES(device_table) = {
        {"uart2", &uart_dev_ops, (void *)&uart2_data },
        {"rtc", &rtc_dev_ops, NULL},
        { "pwm0",   &pwm_dev_ops,  (void *)&pwm_data0},//添加pwm0子设备,"pwm0"名称可自定义
        { "pwm1",   &pwm_dev_ops,  (void *)&pwm_data1},//添加pwm1子设备,"pwm1"名称可自定义
};

\