Symbol 'LED3' for device 'LED_LED3_LED' has extra pin 'C'.

转载于:https://zhidao.baidu.com/question/811428515891146412.html


导出网络表时，报出错误：

#1   ERROR(305) Device/Symbol check error detected.
Symbol 'LED3' for device 'LED_LED3_LED' has extra pin 'C'.
Symbol 'LED3' for device 'LED_LED3_LED' has extra pin 'A'.
Symbol 'LED3' for device 'LED_LED3_LED' is missing pin '1'.
Symbol 'LED3' for device 'LED_LED3_LED' is missing pin '2'.

然后我立即用allegro打开了LED3的封装结果看不到pin number，找了半天看不到，最后在外国网站上看到了处理办法，终于显示出了pin number.

setup / drawing option / display / filled pads, 
if uncheck filled pads, pin number can be displayed.

就是说只要取消filled pads，关闭了填充焊盘选项就可以看到中间的pin number了。

如图看到C和A了，修改方法为：点击Edit - Text 然后选中C或者A，输入1和2就改变了pin number

再次导出网络表，错误没有了

转载于:https://www.cnblogs.com/tureno/articles/8459053.html