数字信号处理实验4-滤波器设计
所属分类:其他
开发工具:matlab
文件大小:119KB
下载次数:6
上传日期:2018-05-31 14:47:33
上 传 者:小可爱然
说明: 对给定的输入信号(基带二进制码元为500Hz,两个载频分别为2kHz和4kHz的FSK调制信号)进行滤波。利用MATLAB编程设计一个数字低通滤波器,指标要求如下:通带截止频率:;阻带截止频率:;采样频率;通带峰值起伏:;最小阻带衰减:。要求分别用MATLAB中的IIR和FIR设计命令进行滤波器设计,得出需要的滤波器系数。再将得到的滤波器系数在MATLAB中编程进行实现(选择直接型实现结果),对输入信号进行滤波,观察滤波
(Filtering the given input signal (base band binary symbol 500Hz, two carrier frequency 2kHz and 4kHz FSK modulation signals) respectively. Using MATLAB programming to design a digital low pass filter, the requirements are as follows: the pass band cut-off frequency: the stopband cut-off frequency: the sampling frequency; the peak fluctuation of the pass band: the minimum stopband attenuation:. The IIR and FIR design commands in MATLAB are used to design the filter, and the required filter coefficients are obtained. The obtained filter coefficients are programmed in MATLAB (the direct result is chosen), the input signals are filtered, and the filtering is observed.)
文件列表:[举报垃圾]
数字信号处理实验4-滤波器设计.doc, 1662278 , 2018-05-31
近期下载者:
相关文件:
收藏者: