# 进入系统视图
<H3C> system-view<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" />

# 创建本地用户geisnetwork,并进入本地用户视图.
[H3C] local-user geisnetwork

# 设置本地用户的认证口令为明文方式,口令为 123456
[H3C-luser-geisnetwork] password 123456
# 设置VTY用户的服务类型为Telnet.
[H3C-luser-geisnetwork] service-type telnet level 3

# 进入VTY0用户界面视图.
[H3C] user-interface vty 0                            

# 设置通过VTY0口登录交换机的Telnet用户进行Scheme认证.
[H3C-ui-vty0] authentication-mode scheme

# 设置从VTY0用户界面登录后可以访问的命令级别为3级别

[H3C-ui-vty0] user privilege level 3

# 设置VTY0用户界面支持Telnet协议.
[H3C-ui-vty0] protocol inbound telnet
#指定vlan1为管理VLAN

[H3C]  management-vlan 1

#创建交换机管理vlan1的vlan接口并进入vlan接口视图

[H3C] interface vlan-interface 1

#配置管理vlan1接口的IP地址为123.253.X.X

[H3C-Vlan-interface1] ip address 123.253.X.X 255.255.255.0
[H3C-Vlan-interface1] quit

#配置缺省路由

[H3C] ip route-static 0.0.0.0 0.0.0.0 123.253.132.65

 

端口限速:

# 进入对应端口

[H3C] interface Ethernet 1/0/X

# 对端口E1/0/X的出方向报文进行流量限制为10Mbps

[H3C] line-rate outbound 10240

# 对端口E1/0/X的入方向报文进行流量限制为10Mbps

[H3C] line-rate inbound 10240

 

 

附:
user-interface vty 4
authentication-mode scheme
local-user xf
password simple bbs

 

service-type ssh level 3

undo ip http shutdown
 

还原: reset sav    

&        reboot