php $cnt 字符串,求助，STM32F407外部计数器模式，CNT的值一直为0，是我哪里设置的不对吗，直接上程序...

//定时器配置为计数器

void TIM2_Cap_Init()

{

GPIO_InitTypeDef GPIO_InitStructure;

TIM_TimeBaseInitTypeDef  TIM_TimeBaseStructure;

RCC_APB1PeriphClockCmd( RCC_APB1Periph_TIM2 ,ENABLE);          //TIM5时钟使能

RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOA, ENABLE);         //使能PORTA时钟

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_0 ; //GPIOA0

GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN;//输入

GPIO_InitStructure.GPIO_Speed = GPIO_Speed_100MHz;        //速度100MHz

GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_NOPULL; //浮空

GPIO_Init(GPIOA,&GPIO_InitStructure); //初始化PA0

TIM_DeInit(TIM2);

TIM_TimeBaseStructure.TIM_Period = 0xFFFF;

TIM_TimeBaseStructure.TIM_Prescaler = 0x00;

TIM_TimeBaseStructure.TIM_ClockDivision = 0x00;

TIM_TimeBaseStructure.TIM_CounterMode = TIM_CounterMode_Up;

TIM_TimeBaseInit(TIM2, &TIM_TimeBaseStructure); // Time base configuration

TIM_ETRClockMode2Config(TIM2, TIM_ExtTRGPSC_OFF, TIM_ExtTRGPolarity_NonInverted, 0);

TIM_SetCounter(TIM2, 0);

TIM_Cmd(TIM2, ENABLE);

}

//主函数

u16 speed = 0;

int main(void)

{

NVIC_PriorityGroupConfig(NVIC_PriorityGroup_2);//设置系统中断优先级分组2

delay_init(168);  //初始化延时函数

uart_init(115200);//初始化串口波特率为115200

TIM14_PWM_Init(1000-1,840-1);               //84M/84=1Mhz的计数频率计数到500,PWM频率为1M/500=2Khz

TIM2_Init(0xFFFFFFFF,0);;

while(1)

{

TIM_SetCompare1(TIM14,200);

speed=TIM2->CNT;

printf("Freq = %d\r\n",speed);

delay_ms(1000);

}

}