三菱m60系统波特率怎么设置_三菱 M60 三菱-M60 M60S series 操作 手册

资料介绍：

efer to the following documents.

MELDAS 60/60S Series Alarm / Parameter Manual ............................................... BNP-B2201

MELDAS 60/60S Series MELDASMAGIC64 Programming Manual (M TYPE)...... BNP-B2182

MELDAS 60/60S Series MELDASMAGIC64 Programming Manual (L TYPE)....... BNP-B2181

In this NC unit, the machining programs, parameters and tool compensation data are saved in

the memory (memory elements). This NC unit's memory is backed up by lithium batteries, and

under normal conditions will last 6 years from the date of manufacture. However, data contents

could be lost under the conditions described below.

To prevent data loss, output important programs, parameters, etc., to a serial input/output device

and save them. Refer to Section "III-8 Maintenance Functions" in this manual for information on

how to do this.

Data in the memory can be lost under these kinds of conditions.

(1) Incorrect operation

Data can be lost if the operator inadvertently changes data while editing a program or setting

parameters.

(This is not really a data loss, but it is a loss from the standpoint that the original data is gone.)

Data can be lost if the operator inadvertently deletes data or initializes NC unit.

(2) Battery life expires

When the battery life expires and there is not enough voltage to store the data in the memory,

data can be lost by turning the power OFF.

(3) Faults

Data can be lost when faults occur and the control unit must be replaced.

< Important Usage Notes >