Rel-18 网络控制中继器（NCR）协议解读

RAN1协议影响

协议修改对应于：TS 38.213 - 20 Network controlled repeater【协议版本i10】

协议原文	协议解读
An NCR includes an NCR-MT entity and an NCR-Fwd entity [19, TS 38.300]. Throughout this specification, unless otherwise noted, statements using the term "UE" in Clauses 4 through 13 are equally applicable to the NCR-MT.	NCR由NCR-Fwd和NCR-MT两部分组成。在协议中，将NCR-MT称为“UE”
A procedure for the NCR-MT to perform cell search, system information acquisition, random access procedure, UCI reporting, or PDCCH monitoring is same as a corresponding one for a UE. A procedure for the NCR-MT to perform PDSCH reception, CSI-RS measurements and CSI determination, PUSCH transmission, or SRS transmission is same as a corresponding one for a UE as described in [6, TS 38.214].	NCR-MT进行小区搜索、系统信息获取、随机接入、UCI上报、PDCCH监听的流程和普通UE相同。NCR-MR进行PDSCH接收、CSI-RS测量上报、PUSCH传输，SRS传输的流程和普通UE相同。
The NCR-Fwd transmits or receives only after the NCR-MT receives on the control link an indication for one or more beams [20, TS 38.106] for the NCR-Fwd to use for transmissions or receptions over corresponding one or more time resources on the access link.	NCR-Fwd的转发开关由控制信息中的波束控制信息隐式确定。（波束指示确定了波束及时域信息，则只有在波束指示所对应的时域资源上，NCR-Fwd才进行转发）
The timing for transmission and reception by the NCR-Fwd on the backhaul link follows the frame timing for transmission and reception, respectively, by the NCR-MT.	NCR-Fwd和NCT-MT的时序信息保持一致（NCR-MT的时序确定方式和普通UE相同）
When the NCR-MT performs a link recovery procedure as described in Clause 6, the NCR-Fwd does not transmit or receive until the link recovery procedure is complete [11, TS 38.321].	当NCR-MT在进行链路失败恢复流程时， NCR-Fwd停止转发
The NCR can be provided, through the NCR-MT, tdd-UL-DL-ConfigurationCommon and can be additionally provided tdd-UL-DL-ConfigurationDedicated. The NCR-Fwd receives on the backhaul link or transmits on the access link only in symbols indicated as downlink by tdd-UL-DL-ConfigurationCommon and, if provided, tdd-UL-DL-ConfigurationDedicated. The NCR-Fwd receives on the access link or transmits on the backhaul link only in symbols indicated as uplink by tdd-UL-DL-ConfigurationCommon and, if provided, tdd-UL-DL-ConfigurationDedicated. If the NCR does not support simultaneous transmissions on control link and the backhaul link, the NCR-Fwd does not transmit over a time resource if the NCR-MT transmits over the time resource.	NCR-MT的上行/下行TDD时序由高层参数 tdd-UL-DL-ConfigurationCommon 和tdd-UL-DL-ConfigurationDedicated确定。NCR-Fwd和NCR-MT的上行/下行时隙保持一致。当上行/下行TDD时间配置为下行时，NCR-Fwd接收NCR-MT的发送信号，或者通过A-link进行数据转发；当上行/下行TDD时间配置为上行时，NCR-Fwd接收通过A-link发送的信号或者通过B-link向基站进行数据转发。如果NCR不支持B-link和C-link同时发送，则B-link和C-link发送在时间上产生冲突时，B-link具有较低优先级（此时不发送）