basler相机出现buffer不足的解决方案

问题描述：
Type Time Source Message
Error 2021-11-22 10:32:20.684 01 (22901290) Image acquisition on “01 (22901290)” failed! Error: 0xe1000014 “The buffer was incompletely grabbed. This can be caused by performance problems of the network hardware used, i.e. network adapter, switch, or ethernet cable. To fix this, try increasing the camera’s Inter-Packet Delay in the Transport Layer category to reduce the required bandwidth, and adjust the camera’s Packet Size setting to the highest supported frame size.”

缓冲区已经被完全使用。这可能是由于使用的网络硬件的性能问题,即网络适配器,开关,或以太网电缆。为了解决这个问题,试着增加相机的Inter-Packet延迟传输层类别来减少所需的带宽,并调整相机的数据包大小设置最高支持的帧的大小。

寻求解决方案中~

正常情况下我们都只会去调整网卡的矩阵包
如果出现这样的情况，需要观察：相机packetsize和packetdelay设的多大
1、packetsize设置不超过巨型帧数值
2、packetdelay一般设置500
如下解决相关问题点