Xshell等连接虚拟机突然不行解决办法

前言

布置大数据环境，之前使用Xshell， 后来改为FinalXshell连接虚拟机，但是偶尔就会那么一下无法连接，咋连都连不上，有时候是一台机器出现问题，有时候三台一起出，但是大多数情况下都是直接重启虚拟机就好了。我就没太在意，今儿又出现三台机子都连不上这问题，下定决心一定要搞定他！

一、发现问题

首先经常重启机器就能好，每次重启重启的有网络服务这块儿，我就去查网络服务是否启动。

admin@master2 ~]$ systemctl status network.service

果然是这里出了问题

重启一次吧， 我不可以接受。

[admin@master2 ~]$ service network restart
Restarting network (via systemctl):  Job for network.service failed because the control process exited with error code. See "systemctl status network.service" and "journalctl -xe" for details.

还是不行

二、查找日志文件

[admin@master2 ~]$ sudo cat /var/log/messages | grep network

Mar  6 13:35:54 master2 systemd: Starting LSB: Bring up/down networking...
Mar  6 13:35:54 master2 network: 正在打开环回接口： [  确定  ]
Mar  6 13:35:54 master2 network: 正在打开接口 ens33： 错误：连接激活失败：****No suitable device found for this connection (device lo not available because device is strictly unmanaged).****
Mar  6 13:35:54 master2 network: [失败]
Mar  6 13:35:54 master2 network: RTNETLINK answers: File exists
Mar  6 13:35:54 master2 network: RTNETLINK answers: File exists
Mar  6 13:35:54 master2 network: RTNETLINK answers: File exists
Mar  6 13:35:54 master2 network: RTNETLINK answers: File exists
Mar  6 13:35:54 master2 network: RTNETLINK answers: File exists
Mar  6 13:35:54 master2 network: RTNETLINK answers: File exists
Mar  6 13:35:54 master2 network: RTNETLINK answers: File exists
Mar  6 13:35:54 master2 network: RTNETLINK answers: File exists
Mar  6 13:35:54 master2 network: RTNETLINK answers: File exists
Mar  6 13:35:54 master2 systemd: network.service: control process exited, code=exited status=1
Mar  6 13:35:54 master2 systemd: Failed to start LSB: Bring up/down networking.
Mar  6 13:35:54 master2 systemd: Unit network.service entered failed state.
Mar  6 13:35:54 master2 systemd: network.service failed.

No suitable device found for this connection (device lo not available because device is strictly unmanaged).

网卡出故障了， 全部重启一下。
分别执行如下代码重启NetworkManager

[admin@master2 ~]$ chkconfig NetworkManager off

[admin@master2 ~]$ sudo chkconfig network on

[admin@master2 ~]$ service NetworkManager stop

[admin@master2 ~]$ service network start

[admin@master2 ~]$ systemctl status network
● network.service - LSB: Bring up/down networking
   Loaded: loaded (/etc/rc.d/init.d/network; bad; vendor preset: disabled)
   Active: active (exited) since 六 2021-03-06 14:16:14 CST; 10s ago
     Docs: man:systemd-sysv-generator(8)
  Process: 5314 ExecStart=/etc/rc.d/init.d/network start (code=exited, status=0/SUCCESS)

网络重启完成。其他两台slave1、slave2同理如此改。
Xshell和FinalXshell就都可以连接了。