STM32--外部中断2试验

stm32f103

软件的配置过程如下图：

 具体的步骤为：

#include "exti2_Irq.h"
#include "LED.h"
#include "delay.h"
void Exti2_Irq(void){
	//定义三个结构体
	GPIO_InitTypeDef GPIO_InitStructure;
	EXTI_InitTypeDef EXTI_InitStructure;
	NVIC_InitTypeDef NVIC_InitStructure;
	
	//初始化GPIO,并使能AFIO复用时钟功能
	RCC_APB2PeriphClockCmd(RCC_APB2Periph_AFIO | RCC_APB2Periph_GPIOE, ENABLE);
	GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IPU;
	GPIO_InitStructure.GPIO_Pin = GPIO_Pin_2;
	GPIO_Init(GPIOE, &GPIO_InitStructure);
	//GPIO映射到EXTI输出线
	GPIO_EXTILineConfig(GPIO_PortSourceGPIOE,GPIO_PinSource2);
	EXTI_InitStructure.EXTI_Line = EXTI_Line2;
	EXTI_InitStructure.EXTI_Mode = EXTI_Mode_Interrupt;
	EXTI_InitStructure.EXTI_Trigger = EXTI_Trigger_Falling;
	EXTI_InitStructure.EXTI_LineCmd =ENABLE;
	
	EXTI_Init(&EXTI_InitStructure);
	//优先级配置
    //组别优先顺序（第0组优先级最强，第4组优先级最弱）：
    //组”优先级别>“抢”占优先级别>“子”优先级别
	NVIC_PriorityGroupConfig(NVIC_PriorityGroup_2);
	NVIC_InitStructure.NVIC_IRQChannel = EXTI2_IRQn;
	NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 1;
	NVIC_InitStructure.NVIC_IRQChannelSubPriority = 2;
	NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;
	NVIC_Init(&NVIC_InitStructure);
}
//中断服务函数，已经在stm32 启动文件中声明（可以在启动文件中找到相应的函数），只需要定义就行
void EXTI2_IRQHandler(void){
	GPIO_ResetBits(GPIOA, GPIO_Pin_8);
	sw_delay_ms(200);
	GPIO_SetBits(GPIOA, GPIO_Pin_8);
	sw_delay_ms(200);
	GPIO_ResetBits(GPIOA, GPIO_Pin_8);
	sw_delay_ms(200);
	GPIO_SetBits(GPIOA, GPIO_Pin_8);
	sw_delay_ms(200);
	
	EXTI_ClearITPendingBit(EXTI_Line2);
	
}