新乡市MedAccred _AC8121电子电缆和线束组件的审核标准 （55）

29.5 C- Are only authorized splices being performed in production?YES/NO

29.6 C- Are personnel aware of the limitations on splicing for production?YES/NO

29.7 C- Is there evidence of splicing performed in accordance with procedures / customer requirements?YES/NO

29.8 C- If repair splices are authorized, is there evidence for all repair splices?YES/NO/NA

29.9 C- Is there evidence that following splice processes are being performed in accordance with procedures:

29.9.1 C- Soldered splices, including solder sleeve splices?YES/NO/NA

29.9.2 C- Crimp splices?YES/NO/NA

29.10 C- Is the procedure for acceptance criteria of each of the following splices available and being followed:

29.10.1 C- Soldered splices, including solder sleeve splices?YES/NO/NA

29.10.2 C- Crimp splices?YES/NO/NA

29.11C- Is sleeving shrunk and snug (no lateral movement) to the wire splice and wire insulation maintaining sufficient sleeving thickness over the wire splice?YES/NO

29.12 C- If used, are stranded wires formed in soldered splices (other than mesh) tinned?YES/NO/NA

29.13 C- Does the sleeving conform to the splice contour and have a snug fit over the wire splice area and wire insulation?YES/NO

29.14 C- Does the sleeving cover the wire insulation on both ends of the spliced area by a minimum of 1 diameter of the wire group?YES/NO/NA

29.15 C- Is the appropriate sleeving / tubing used to insulate the splice?YES/NO

29.16 C- If used, are mesh splice strands prevented from being tinnedYES/NO/NA

29.17 C- If used, are wire strands for mesh splices interlaced together so the strands interlace evenly and are of equal length?YES/NO/NA

29.18 C- If used, are lap solder splices formed so that wires have the proper overlap?YES/NO/NA

29.19 C- If used, are lap solder splices formed so that solder has wet to all elements of the termination forming a visible solder fillet joining the wires for the length of the overlapped area of the splice?YES/NO/NA

29.20 C- If used, are solder preforms used in heat shrinkable solder sleeve devices completely melted and the solder fillet is wet to the wires in the connection?YES/NO/NA