CCNA动手实验（九）配置tunnel隧道

最新推荐文章于 2024-06-14 13:37:46 发布

水下日月

最新推荐文章于 2024-06-14 13:37:46 发布

阅读量1.5k

点赞数 2

文章标签：网络

本文链接：https://blog.csdn.net/weixin_68156595/article/details/125255866

版权

一实验要求

1.在R2与R4之间建立一个tunnel隧道

2.R1能通过隧道ping同R5

二实验步骤

1.在各个路由器上配置IP地址。

Router>
Router>en
Router#
Router#conf
Configuring from terminal, memory, or network [terminal]? 
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Router(config)#ho R1
R1(config)#int g0/0
R1(config-if)#ip add 10.1.1.1 255.255.255.0
R1(config-if)#no sh

Router>
Router>en
Router#
Router#conf
Configuring from terminal, memory, or network [terminal]? 
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#ho R2
R2(config)#int g0/0
R2(config-if)#ip add 10.1.1.2 255.255.255.0
R2(config-if)#no sh

R2(config-if)#
%LINK-5-CHANGED: Interface GigabitEthernet0/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0, changed state to up

R2(config-if)#int g0/1
R2(config-if)#ip add 10.1.2.1 255.255.255.0
R2(config-if)#no sh

R2(config-if)#
%LINK-5-CHANGED: Interface GigabitEthernet0/1, changed state to up
exit
R2(config)#do ping 10.1.1.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.1.1, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 0/0/0 ms
R2(config)#int loopback 0

R2(config-if)#
%LINK-5-CHANGED: Interface Loopback0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed state to up

R2(config-if)#ip add 2.2.2.2 255.255.255.255
R2(config-if)#no sh

Router>en
Router#
Router#conf
Configuring from terminal, memory, or network [terminal]? 
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#ho R3
R3(config)#int g0/0
R3(config-if)#ip add 10.1.2.2 255.255.255.0
R3(config-if)#no sh

R3(config-if)#
%LINK-5-CHANGED: Interface GigabitEthernet0/0, changed state to up

%LINEPROTO-5-UPDOWN: Line proto