[SDX62] WCN6856设置国家码为GB,发现无法设置100及以上的信道，设置之后无法扫描到SSID问题分析及解决

wellnw

已于 2024-08-20 09:48:19 修改

阅读量1.1k

点赞数

分类专栏： WiFi Driver 文章标签： WiFi

于 2022-12-26 15:30:01 首次发布

本文链接：https://blog.csdn.net/wgl307293845/article/details/128444609

版权

WiFi Driver 专栏收录该内容

112 篇文章 33 订阅 ¥129.90 ¥299.90

订阅专栏

超级会员免费看

问题描述

设置国家码为GB,然后将AP设置为100信道80MHz频宽，发现终端无法扫描到SSID热点

hostapd启动日志


WPS: Converting display to virtual_display for WPS 2.0 compliance
WPS: Converting push_button to virtual_push_button for WPS 2.0 compliance
Failed to check if DFS is required; ret=-1
Device is trying to offload WPS Probe Response while not supporting this
Failed to check if DFS is required; ret=-1
wlan0: interface state COUNTRY_UPDATE->ENABLED
wlan0: AP-ENABLED
Failed to check if DFS is required; ret=-1
wlan0: IEEE 802.11 driver had channel switch: freq=5500, ht=1, vht_ch=0x0, he_ch=0x0, offset=1, width=3 (80 MHz), cf1=5530, cf2=0
wlan0: CTRL-EVENT-CHANNEL-SWITCH freq=5500 ht_enabled=1 ch_offset=1 ch_width=80 MHz