启动多路径,通过mpathconf命令创建默认模板。创建默认配置,启动和激活multipathd进程,可以使用以下命令:
mpathconf --enable --with_multipathd y
配置完成后建议重新启动多路径软件:
/etc/init.d/multipathd restart
备注:启动完成后会在/etc/下生成multipath.conf 文件
以及在/etc/multipath下生成bindings 及wwid,
其中wwid记录了系统中所有挂载盘的盘唯一ID
Bindings记录了ID对应的映射盘
一般绑定完后会在/dev/mapper下产生类似于mpathx等文件
[root@perass multipath]# ls -ltr
-rw-------. 1 root root 692 12?9 2013 bindings
-rw-------. 1 root root 586 12?9 2013 wwids
[root@perass multipath]# cat bindings
# Multipath bindings, Version : 1.0
# NOTE: this file is automatically maintained by the multipath program.
# You should not need to edit this file in normal circumstances.
#
# Format:
# alias wwid
#
mpatha 36782bcb01a2c77001945139a07659075
mpath
Linux 6 配置multipath
最新推荐文章于 2024-07-24 04:27:41 发布
本文介绍了如何在Linux系统中启用和配置multipath,包括使用mpathconf命令创建默认模板,启动和激活multipathd服务,并通过重启multipathd来应用配置。配置完成后,系统会在/etc下生成multipath.conf文件以及在/etc/multipath下生成bindings和wwids文件,用于记录设备的盘唯一ID和映射信息。最后,通过multipath -ll命令展示了多路径的详细信息。
摘要由CSDN通过智能技术生成