16. dual_speaker调试

1.修改mk文件
	- KST_KERNEL_BOARD_CUSTOM03 = 
	+ KST_KERNEL_BOARD_CUSTOM03 = KST_TWO_SPEAKER
	
	- KST_MISC_CUSTOM= KST_SUB_FLASH_SUPPORT 
	+ KST_MISC_CUSTOM= KST_SUB_FLASH_SUPPORT KST_AUDIO_SUPPORT_2IN1_SPEAKER KST_TWO_SPEAKER


2.修改dws
	对比已实现dual_speaker的项目，发现需要更改gpio20配置
	

3.修改dts,添加GPIO20的配置
	/* AUdio_extal_AMP_GPIO  Kernel Standardization start */
	&pio {
		pinctrl_audioss1: pinctrl_audioss1@gpio20 {
			pins_cmd_dat {
				pins = <PINMUX_GPIO20__FUNC_GPIO20>;
				slew-rate = <1>;
				bias-pull-up = <00>;
			};
		};

		pinctrl_audioss1_low: pinctrl_audioss1_low@gpio20 {
			pins_cmd_dat {
				pins = <PINMUX_GPIO20__FUNC_GPIO20>;
				slew-rate = <1>;
				output-low;
				bias-pull-up = <00>;
			};
		};

		pinctrl_audioss1_high: pinctrl_audioss1_high@gpio20 {
			pins_cmd_dat {
				pins = <PINMUX_GPIO20__FUNC_GPIO20>;
				slew-rate = <1>;
				output-high;
				bias-pull-up = <00>;
			};
		};

	   };
	&audioss {
		pinctrl-names = "audioss_default", "pinctrl_audioss0", "pinctrl_audioss0_low", "pinctrl_audioss0_high","pinctrl_audioss1", "pinctrl_audioss1_low", "pinctrl_audioss1_high";
		pinctrl-0 = <&audioss_default>;
		pinctrl-1 = <&pinctrl_audioss0>;
		pinctrl-2 = <&pinctrl_audioss0_low>;
		pinctrl-3 = <&pinctrl_audioss0_high>;
		pinctrl-4 = <&pinctrl_audioss1>;
		pinctrl-5 = <&pinctrl_audioss1_low>;
		pinctrl-6 = <&pinctrl_audioss1_high>;

		status = "okay";
	};
	/* AUdio_extal_AMP_GPIO Kernel Standardization end */