来自:Matlab文档
WARNING: rcosflt is not recommended. Use RCOSDESIGN instead.
Y = rcosflt(X, Fd, Fs, TYPE_FLAG, R, DELAY)
Fd (Hz):X的输入频率
Fs (Hz):Y的输出频率【Fs必须是Fd.整数倍】
TYPE_FLAG指定滤波器的选型或者设计
R :roll-off factor 指定滤波器的过渡频带
DELAY :从滤波器的开始到脉冲响应峰值的时间延迟
R:the roll-off factor specifies the excess bandwidth of the filter. R must be in the range [0, 1]. For example, R = .5 means that the bandwidth of the filter is 1.5 times the input sampling frequency, Fd. This also means that the transition band of the filter extends from .5 * Fd and 1.5 * Fd. Since R is normalized to the input sampling frequency, Fd, it has no units. Typical values for R are between 0.2 to