OK6410之ADC驱动硬件分析---阻塞与…

在OK6410开发板中，有AD CONVERT部分，接口为XDAC_AIN0

 

在S3C6410的PDF中：

The 10-bit/12-bit CMOS ADC (Analog to Digital Converter) is a recycling type device with 8-channel analog 
inputs. It converts the analog input signal into 10-bit/12-bit binary digital codes at a maximum conversion rate of
1MSPS with 5MHz A/D converter clock. A/D converter operates with on-chip sample-and-hold function. The 
power down mode is supported. 

 

转换速度：

When the PCLK frequency is 50MHz and the prescaler value is 49, total 10-bit or 12-bit conversion time is as 
follows. 
  A/D converter freq. = 50MHz/(49+1) = 1MHz 
  Conversion time = 1/(1MHz / (5cycles)) = 1/200KHz =5 us

 

触摸屏接口模式：

1. Normal Conversion Mode (AUTO_PST=0, XY_PST=0) 
The operation of this mode is identical with AIN0~AIN3’s. It can be initialized by setting the ADCCON (ADC 
Control Register) and ADCTSC (ADC touch screen control register). All of the switches and pull-up resister 
should be turned off (reset value 0x58 makes switches turn-off). The converted data can be read out from 
ADCDAT0 (ADC conversion data 0 register). 

 

在AD数据采集中，编程方式可采用中断或轮询的方式：在中断方式中，如果采集完毕，硬件会产生中断，在Linux驱动中断编号为IRQ_ADC

1.  The A/D converted data can be accessed by means of interrupt or polling method. With interrupt method, the 
overall conversion time - from A/D converter start to convert data read - may be delayed because of the return 
time of interrupt service routine and data access time. With polling method, by checking the ADCCON [15] – 
end of conversion flag – bit, the read time from ADCDAT register can be determined.

ADC寄存器：

 

在ADC控制寄存器中：

 

在ADC数据寄存器中：