How to install sand making machine?

Henan Daswell Machinery CO.,LTD as a professional manufacturer of sand making machine in Henan, and our products are populared all over the world. As some sand and gravel manufacture are lack of the knowledge of sand making machine. following our engineers will give some suggestion about installation and procedures about sand making machine.

When install a sand making machine, be sure to check the equipment installation site, as well as standby equipment to be installed. only to ensure all that ready fully, can we ensure there were no problems in the later installation process. Following is installation steps of sand making machine.

1. Check into the size and location of the deviation of the discharge port and casting quality: clean surface, free of grease, debris, but does not allow leakage reinforced concrete bare on the outside, and the missing angle of crack.

2. The basis of the size and position deviation should be in accordance with the following criteria: view the coordinates of Dimensions based position measurement requirements of vertical and horizontal axis error is less than 20mm, different parallel to the surface of the standard height of less than 20mm: should be less than the full length of the gradient error 20mm, the upper surface roughness should be less than 5mm, the discharge end and the data allows only negative is not allowed to.

3. Acceptance of the equipment, the staff in accordance with the packing slip, all the size of the parts and documents, check to see if the lack of deformation, the data do record.

4. Before installation, clear the packaging protective film and dust oil, pre-test and pre-assemble components and critical mating parts, in order to avoid rework in the installation work, ensure the progress and quality of the installation.

More information,please visit http://www.dwcrusher.com/

来自 “ ITPUB博客 ” ，链接：http://blog.itpub.net/27663704/viewspace-743177/，如需转载，请注明出处，否则将追究法律责任。

转载于:http://blog.itpub.net/27663704/viewspace-743177/