【K70EK_T7_MQX例程】022RTC实时时钟

By Mcuzone

调试串口波特率：115200-uart2
基于MDKK70-EK_T7硬件平台

初始化同步RTC日期（程序中由用户定义）给MQX的时间（以秒计数从1970.1.1到当前时间的秒数）
设置停止RTC和闹钟警告的中断
10秒后报警触发，一分后停止中断触发
清除RTC到1970.1.1 00:00:00，并重新设置10秒的报警中断
10秒后报警中断触发
把MQX的时间同步给RTC
结束


串口输出：
Start time (MQX synchronized to RTC time during bsp init):

MQX : 1388570880 s, 2 ms (01.01.2014 10:08:00 )
RTC : 01.01.2014 10:08:00 (1388570880 s, 000 ms)

Installing RTC interrupt for stopwatch and alarm ... OK
Stopwatch set to 1 minute (next whole minute) ... OK

Setting alarm to 10 seconds to 01.01.2014 10:08:10 ... OK
Wasting time ...

ALARM!
RTC : 01.01.2014 10:08:11 (1388570891 s, 000 ms)
Continue wasting time (2 minutes max) ...

STOPWATCH!
RTC : 01.01.2014 10:09:01 (1388570941 s, 000 ms)

Clearing RTC:
RTC : 01.01.1970 00:00:01 (01 s, 000 ms)

Setting alarm to 10 seconds to 01.01.1970 00:00:11 ... OK
Wasting time ...
ALARM!
RTC : 01.01.1970 00:00:12 (12 s, 000 ms)
Synchronize RTC to MQX time again:
RTC : 01.01.2014 10:09:12 (1388570952 s, 000 ms)
Finish, press/hold reset to repeat.

 

 

串口输出:

例程及示例：

链接: http://pan.baidu.com/s/1ntLkFZN 密码: 9v63