How to use JFlash

最新推荐文章于 2024-02-26 09:00:00 发布

jtagjava

最新推荐文章于 2024-02-26 09:00:00 发布

阅读量379

点赞数

文章标签： download user each

本文链接：https://blog.csdn.net/jtagjava/article/details/4794291

版权

在使用JFlash v3.42b向LPC2214下载固件时遇到问题，设备无法正常启动。升级到JFlash v4.02和v4.08后问题解决。分析发现，在0x00000014地址处缺少32位校验和导致了设备运行状态异常。

摘要由CSDN通过智能技术生成

There is a problem happen when download firmware to the LPC2214 with JFlash v3.42b, the unit will not be turned on when power is on.

But the download will be ok when I use JFlash v4.02 and v4.08, the unit will running normally.

I have readout the code in the MCU after each download respectly, a difference was found, the one which can run normally has a 32bits checksum value in the address of 0x00000014, this value affect the running status switch from prog to user app.to see detail please refer to LPC2214 user guide.
this checksum words is not generated when I use v3.42b.Now I am still searching for the reason.