S交换机堆叠方案配置指南

Eda_月白秋心

已于 2022-07-25 21:07:58 修改

阅读量2.6k

点赞数 2

文章标签：网络华为

于 2022-07-25 21:05:36 首次发布

本文链接：https://blog.csdn.net/m0_46129105/article/details/125983291

版权

S交换机堆叠方案配置指南

设备堆叠连线原则

交换机A的堆叠逻辑口1连接交换机B的堆叠逻辑口2，该原则很重要！很重要！很重要！

设备堆叠连线配置规划

以S5731双堆叠为例
在这里插入图片描述

设备堆叠连线配置命令参考

**S5731-S48P4X-01**
 
**********Configure stack-port**********
[SW1] interface stack-port 0/1
[SW1-stack-port0/1] port interface XGigabitEthernet 0/0/1 enable
Warning: Enabling stack function may cause configuration loss on the interface. Continue? [Y/N]:y
[SW1-stack-port0/1] quit
[SW1] interface stack-port 0/2
[SW1-stack-port0/2] port interface XGigabitEthernet 0/0/3 enable
Warning: Enabling stack function may cause configuration loss on the interface. Continue? [Y/N]:y
[SW1-stack-port0/2] quit
#
**********Configure priority**********
#
[SW1] stack slot 0 priority 125
[SW1] stack slot 0 renumber 1
#
 
 
**S5731-S48P4X-02**
 
**********Configure stack-port**********
[SW2] interface stack-port 0/1
[SW2-stack-port0/1] port interface XGigabitEtherne 0/0/1 enable
Warning: Enabling stack function may cause configuration loss on the interface. Continue? [Y/N]:y
[SW2-stack-port0/1] quit
[SW2] interface stack-port 0/2
[SW2-stack-port0/2] port interface XGigabitEtherne 0/0/3 enable
Warning: Enabling stack function may cause configuration loss on the interface. Continue? [Y/N]:y
[SW2-stack-port0/2] quit
#
[SW2] stack slot 0 renumber 2