Redis无法远程连接

背景:IDEA上写Jedis的Demo需要连接虚拟机上的redis服务,出现报错

redis.clients.jedis.exceptions.JedisDataException: DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.

这个错误是因为Redis服务器运行在受保护模式下，没有指定绑定地址和认证密码。要解决这个问题，你可以选择以下方法之一：

1. 通过连接到Redis服务器的主机上的回环接口发送命令CONFIG SET protected-mode no来禁用受保护模式。但是请确保在执行此操作后，Redis服务器不会公开暴露在互联网上。使用CONFIG REWRITE使更改永久生效。

2. 通过编辑Redis配置文件，将受保护模式选项设置为'no'，然后重新启动服务器。

3. 如果你只是为了测试而手动启动了服务器，可以使用--protected-mode no选项重新启动它。

4. 设置一个绑定地址或认证密码。

注意：只需要执行上述操作之一，服务器就可以开始接受来自外部的连接。

 

动手实操

虚拟机防火墙关闭

 systemctl stop firewalld.service

在虚拟机redis下关闭保护模式,设置密码

问题解决